How to Play Back Dash Cam Footage?

1 Answers
AngeloAnn
07/29/25 3:19pm
Dash cam playback method: Select the playback function on the dash cam, use the function keys to adjust to the desired time point for playback, and you can view the footage recorded by the dash cam. Alternatively, you can remove the memory card from the dash cam, connect it to a computer, and search for the recording by time point. Dash cams are mainly divided into two categories: portable dash cams and aftermarket in-dash DVD dash cams. Portable dash cams are further divided into rearview mirror dash cams and data dash cams, which feature good concealment, easy installation, detachable and replaceable design, and simple operation. Aftermarket in-dash DVD dash cams are vehicle-specific and can be divided into front-installation and rear-installation types. Installing this type of dash cam is more challenging, but it can maintain the aesthetics of the car interior. Additionally, some luxury models come with pre-installed dash cams from the factory.
Was this review help?
2
2
Share
More Forum Discussions

How to Clean a Car Cover?

First, turn the dirty side inside out and soak it in water. For heavily soiled areas, you may need to soak for a longer time. After soaking, find a large flat area to lay out the car cover and use a laundry brush to scrub the dirty spots. Once the car cover is thoroughly brushed, rinse it clean with water and let it dry.
8
5
Share

Steps to Perfectly Fix Water Leakage Above the Car Door

First, close the windows and use a water gun to spray and identify the leakage location. Roll down the window at the leaking area, then use tape to seal it neatly.
16
0
Share

What to Do When the Solar-Powered ETC Device Runs Out of Power?

When a solar-powered ETC device runs out of power, it needs to be replaced with a new one. Types of ETC devices: 1. ETC devices with built-in batteries; 2. ETC devices with solar panels. The latter do not require manual battery charging during use, as they automatically charge while in operation. Installation method for ETC devices: 1. The ETC sensor is installed on the inside of the car's windshield, secured by a small round plastic suction cup that adheres to the windshield without obstructing the driver's front view. 2. Plug the sensor's wiring harness connector into the sensor's port. The wiring harness is connected through the car's internal network, branching out from the vehicle's intelligent information system, and is wrapped along the interior roof trim panel. 3. Take out the express card and gently insert the side with the chip facing forward into the card slot of the ETC sensor. 4. Once the sensor detects the ETC express card, the sensor's display will light up, showing a message indicating that billing has started.
20
2
Share

What are the penalties for driving an uninspected motorcycle?

The traffic management department of the public security organ shall detain the motor vehicle and notify the party to provide the corresponding license plate, mark, or complete the corresponding procedures. If a motor vehicle driver violates the road traffic safety laws and regulations regarding road traffic regulations, they shall be given a warning or fined.
7
2
Share

How to Turn Off Automatic Music Playback via Car Bluetooth?

Because the audio was left on after listening to music last time before parking, in this case, simply press the button on the left side of the central control screen to turn it off. Also, press the menu button to keep the central control screen on the main interface, not on the Bluetooth audio interface.
16
2
Share

How to Turn Off the Rear Wiper on a Lynk & Co?

The wiper switch of the Lynk & Co 01 is in the form of a stalk, located on the right rear side of the steering wheel. The rear wiper control switch of the Lynk & Co 01 is located below the right side of the steering wheel. Pull it back one notch to turn off the rear wiper.
11
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.