How to Pay Traffic Fines for a Vehicle Not Under Your Name?

1 Answers
LeDawson
07/28/25 5:03pm
The driver can choose to process the violation either at a traffic violation handling window or through the "Traffic Management 12123" app by registering a vehicle not under their name. After registration, they can handle traffic violations that occurred from the date of registration, which involve demerit points and a single fine not exceeding 200 yuan. There are two types of violations: 1. On-site violations: These refer to traffic fines issued on the spot by traffic police when a driver violates traffic regulations. For example, if a parking ticket is issued, this is an on-site violation. The owner can directly pay the fine at the bank specified on the ticket. 2. Non-on-site violations: Generally, these refer to violations captured by electronic surveillance, such as running a red light or speeding, where evidence is collected by traffic police. For such violations, they only need to be processed within one demerit point cycle.
Was this review help?
17
4
Share
More Forum Discussions

How to Activate Left and Right Turn Signals in a Car?

Car turn signal switches are generally located on the left side of the steering wheel. You need to push the lever upward to activate the indicator. After operation, the dashboard will display the right turn signal icon, and the right turn signals at both the front and rear of the vehicle will illuminate.
15
1
Share

How to Dispose of Old Tires After Replacement?

When your vehicle's old tires are replaced, remember not to discard them randomly as they can cause environmental pollution. The removed old tires can be sold to recycling shops or to tire repair technicians.
1
2
Share

What to Do If the Delivery of BYD Qin Plus Takes Too Long?

You can call the customer service of the vehicle purchase to inquire about the progress of your vehicle. If the vehicle was purchased at a local 4S store, you can also visit the store directly to inquire and remind them to deliver the vehicle as soon as possible.
1
4
Share

How to Connect Jumper Cables?

Before connecting jumper cables, always turn off the engine first. The cables must be connected strictly following the correct sequence, and the two vehicles must not touch each other. The disconnection sequence is exactly the opposite: first remove the ground cable, then the negative terminal, followed by the positive terminal of the live vehicle, and finally the positive terminal of the dead vehicle.
14
5
Share

What to Do When an Automatic Car Won't Start?

First, check if there is no fuel in the tank and replenish the engine oil promptly if needed. A dead or faulty battery can also prevent the car from starting. You can remove the battery for charging or jump-start it. If the battery is faulty, it should be taken to a repair shop for servicing.
6
2
Share

How to Disassemble a Mazda 6 Key?

Release the lock button at the rear end of the smart key and pull out the mechanical key. Insert a flat-head screwdriver with its blade wrapped in cloth into the gap at the corner and twist to separate the upper and lower parts, then replace the new battery.
4
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.