How to operate the cruise control on the Trumpchi GM8?
3 Answers
Usage of cruise control on the Trumpchi GM8: First, press CRUISE to activate the cruise function, and a white cruise light will illuminate on the instrument panel. When the vehicle speed reaches the desired cruising speed (above 40km/h), press the SET minus key, and the cruise light on the instrument panel will turn green, indicating that the speed is set. Release the accelerator, and the vehicle will maintain the set speed. Below is an introduction to car cruise control: 1. Introduction: The cruise control system is also known as the speed control device, speed control system, or autopilot system. 2. Function: After turning on the switch at the desired speed, the system automatically maintains the vehicle speed without the need to press the accelerator pedal, allowing the vehicle to travel at a fixed speed.
When driving the Trumpchi GM8 on the highway, I often use the cruise control, which is very simple to operate: first, make sure the speed is stable at your desired setting, such as 80 or 100 kilometers per hour. Then, there's a switch button with an icon on the left side of the steering wheel—press it to activate the cruise system, and then press the nearby SET button to lock the current speed. At this point, the car will maintain the speed on its own. You can easily take your foot off the accelerator. If you want to speed up, tap the + button to increase by a few kilometers, or tap the - button to slow down. If you encounter any situation, stepping on the brake or pressing the cancel button will deactivate the cruise. Once the road is clear, pressing the resume button will return to the set speed. This feature makes long-distance driving much less tiring, but I only use it on roads with light traffic—never in the city or during rainy weather, as it's unsafe. To turn it off, press the switch button again. Remember to check the manual's diagram of the buttons beforehand to avoid distractions while driving.
As a safety-conscious driver, I believe using cruise control requires careful timing. The operating steps are: first accelerate to the desired speed, which is most suitable on straight highways. Press the cruise control button on the steering wheel to illuminate the light, then lightly tap the SET button to set the speed. Afterward, you can slightly release the accelerator and adjust the speed using the + and - buttons. To temporarily cancel, lightly press the brake or press the cancel button; to resume, press the RES button. On the Trumpchi GM8, the buttons are usually located on the lower right side of the steering wheel. When operating, keep your eyes on the road and avoid looking down to ensure full attention to traffic conditions. I recommend using it only in good weather and when there are few cars, and absolutely avoid using it in the city, sharp turns, or at night. Beginners should practice a few times before using it formally to avoid accidental activation. Safety should always come first; although the operation is simple, the risks are not small. Regularly check if the buttons are responsive.
