···
Log in / Register

How to Operate a Manual Gear Stick?

1 Answers
DeEmmanuel
07/29/25 1:50am

Here are the steps to operate a manual gear stick: 1. Start in first gear, then shift to second gear once the vehicle begins moving. 2. Shift to third gear when the speed reaches above 30 km/h but below 35 km/h. 3. Shift to fourth gear when the speed is between 35 km/h and 45 km/h. 4. Use fifth gear when the speed exceeds 45 km/h. Additional notes: It's important to monitor the engine RPM during gear shifts, ideally shifting at around 2500 RPM. If you feel the vehicle shaking during normal driving, it indicates the engine is operating under high load at low speed, and you should appropriately downshift by one or two gears.

Was this review help?
5
3
Share
More Forum Discussions

Is the VIN on the vehicle's license?

The vehicle's license does not display the VIN (Vehicle Identification Number). The VIN can be found in the following locations: 1. Left side of the dashboard; 2. Lower left side of the windshield; 3. On the vehicle's nameplate; 4. Upper body near the right front shock absorber; 5. In the trunk area; 6. On the door hinge pillar, door lock pillar, or one of the door edges connected to the lock pillar. The VIN is a 17-character code that identifies the vehicle's manufacturer, year, model, body type, engine code, and assembly location. Its purposes include: 1. Verifying vehicle identity; 2. Traffic violation inquiries; 3. Checking vehicle batches; 4. Precise parts identification.
15
5
Share

What car brand has a T-shaped logo?

A T-shaped logo represents Tesla vehicles, which include models such as Tesla Model Y, Tesla Model 3, Tesla Model YX, Tesla Model YS, and Tesla Model 3 Import. Taking the 2021 Tesla Model YX as an example, it belongs to the mid-to-large-sized car category with body dimensions of 4979mm in length, 1964mm in width, and 1445mm in height, with a wheelbase of 2960mm. The 2021 Tesla Model YX is equipped with a permanent magnet motor, delivering a maximum horsepower of 538ps, a maximum power of 395kw, and a maximum torque of 755nm, paired with a single-speed fixed gear ratio transmission.
20
3
Share

What Causes Car Idle Shaking?

Car idle shaking is caused by: 1. Severe engine carbon buildup; 2. Dirty throttle body or excessive injector carbon deposits; 3. Faulty spark plugs, high-voltage wires, or ignition coils leading to poor ignition system performance; 4. Unstable fuel pressure, insufficient fuel pump supply pressure, or incorrect intake pressure sensor readings; 5. Fuel line blockage causing insufficient fuel supply; 6. Aging engine components. Solutions for car idle shaking: 1. Clean engine and idle motor carbon deposits; 2. Clean fuel lines; 3. Replace spark plugs, high-voltage wires, and ignition coils; 4. Clean air filter and throttle body; 5. Replace aging engine components.
15
4
Share

Which company owns Neta Auto?

Neta Auto is a brand under Hozon New Energy, with models including Neta NO1, Neta U, Neta V, Neta ETAKE, Neta Eureka 02, etc. Taking Neta U as an example, it belongs to the compact SUV category, with body dimensions of: length 4530mm, width 1860mm, height 1628mm, wheelbase 2770mm, front track 1398mm, and rear track 1373mm. The Neta U is equipped with a permanent magnet DC motor, delivering a maximum horsepower of 164ps, maximum power of 120kw, maximum torque of 210nm, and is paired with a 1-speed fixed gear ratio transmission.
17
3
Share

Do You Need to Press the Brake When Shifting Gears in an Automatic Transmission?

Shifting gears in an automatic transmission does not require pressing the brake. However, there are situations in an automatic transmission car where you need to press the brake: 1. When shifting from P (Park) to other gears, you need to press the brake; 2. When shifting from N (Neutral) to D (Drive) or R (Reverse), you need to press the brake. The method to start an automatic transmission car: 1. Turn the ignition key to the second position (power mode), and the car's computer system will begin self-check; 2. Press the foot brake and shift the gear from P to N; 3. Release the foot brake and turn the ignition key to the start position. An automatic transmission does not require the driver to manually shift gears; the vehicle will automatically select the appropriate gear based on driving speed and traffic conditions. The gear positions in an automatic transmission car, from top to bottom, are: P (Park), R (Reverse), N (Neutral), D (Drive), S (Sport), and L (Low).
2
3
Share

How to Adjust the Headlight Height of the Honda Vezel?

Honda Vezel's headlight height adjustment method is: 1. Locate the headlight adjuster in the middle of the door; 2. Rotate the knob - the higher the roller number, the lower the angle. Taking the 2020 Honda Vezel as an example, it belongs to the compact SUV category with body dimensions of: length 4328mm, width 1772mm, height 1605mm, wheelbase 2610mm, fuel tank capacity 50L, luggage compartment volume 437L, and curb weight 1227kg. The 2020 Honda Vezel is equipped with a 1.5L naturally aspirated engine delivering maximum horsepower of 131PS, maximum power of 96kW, maximum torque of 155Nm, paired with a 6-speed manual transmission.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.