···
Log in / Register

How to Open the Trunk of Trumpchi GM6?

3 Answers
McSara
09/01/25 7:20am
Method to open the trunk of Trumpchi GM6: The bottom button on the remote key of the Trumpchi GM6 is used to open the trunk. However, after opening, you still need to manually lift the lid or press the button at the rear of the vehicle. The interior of the Trumpchi GM6 trunk is quite tidy and deep. The third-row seats support a 40:60 split folding and can be folded and stored, forming a flat floor after storage, allowing for personalized space utilization. The dimensions of the Trumpchi GM6 are 4780 mm in length, 1860 mm in width, and 1730 mm in height, with a wheelbase of 2810 mm. In terms of power, the Trumpchi GM6 is equipped with a 1.5T turbocharged engine, delivering a maximum horsepower of 171 hp and a maximum torque of 265 Nm, paired with a 6-speed manual or Aisin 6-speed automatic transmission.
Was this review help?
3
4
Share
DeRyan
09/14/25 3:05am
Last time I drove my friend's GM6 and did some research. Opening the trunk of this car is actually quite convenient. Just press the black button on the tailgate—it's a circular button with a slight damping feel when touched. If your hands are full, you can also press and hold the trunk icon in the middle of the remote key for three seconds to automatically pop it open. I prefer using the switch on the driver's door panel, located next to the window control area—just press the button with a car rear pattern, and it's done. Note that for models before 2019, this button was below the left AC vent on the driver's side, but from the 2020 model onwards, it was moved next to the overhead light. If you've opted for the power tailgate, the kick sensor is even more convenient—just remember to have the key on you. To close it, simply pull the handle on the inner side of the tailgate or press the power close button. The anti-pinch design is quite thoughtful.
Was this review help?
10
0
Share
Expand All
Emil
10/28/25 3:48am
Remember these three points when opening the GM6 rear door: There's a rubber button on the right side of the tailgate handle—press it while slightly lifting the tailgate. On the car key, the bottom button with a cargo compartment icon automatically unlocks and pops open when held for two seconds. For newer models, there's a row of five-door switch groups near the reading light above the driver's seat—the rectangular button with wave patterns on the far right controls the rear door. The key works within two meters of the car, which is especially convenient on rainy days without needing to take it out. However, base models don’t have a power tailgate—manual opening requires attention to the pulling angle, and it’s easier to press the button with your right hand while supporting the door bottom with your left. Owners of older models should check the manual—my experience is that there’s an easily overlooked recessed button on the lower left side of the center console near the driver.
Was this review help?
2
4
Share
Expand All
More Forum Discussions

Should You Shift to Neutral at a Red Light with an Automatic Transmission?

When waiting at a red light with an automatic transmission car, it is recommended to shift to neutral. If the wait is longer, you can also engage the handbrake. Here are the relevant details: 1. In situations like waiting at traffic lights, traffic jams, or picking up passengers where temporary parking is required, many drivers are accustomed to the "D gear + brake pedal" method. However, this habit is not ideal. If the parking time is short (e.g., within 20 seconds), the gear lever can remain in D position while only pressing the brake pedal. 2. For slightly longer waits, it is best to use "N gear + handbrake" to reduce driver fatigue and prevent the automatic transmission fluid from overheating, which could affect its quality.
9
5
Share

How to Remove Odor from a New Car?

Here are quick methods to eliminate odors from a new car: 1. Use bamboo charcoal bags, which have strong odor-absorbing capabilities and are both long-lasting and fast-acting; 2. Develop the habit of opening doors and windows before driving to allow circulating air to dilute and disperse toxic gases inside the cabin, and try to keep windows open as much as possible while driving; 3. Use fruit peels, such as pomelo and lemon, which also have odor-removing effects. Additional information: The reason for odors in new cars is the inclusion of various materials during manufacturing, such as leather, plastic panels, soundproofing cotton, adhesives, and asphalt. These materials often contain odors like formaldehyde, which accumulate in the confined space of the car. Poor air circulation makes it difficult for the odors to dissipate, resulting in a pungent smell when entering the car.
18
3
Share

What does BCM mean in automotive circuits?

Automotive BCM refers to the Body Control Module, which primarily controls the electrical appliances in the vehicle body, such as the entire vehicle's lighting system, wipers, washers, door locks, power windows, sunroof, power mirrors, and remote control. The following are the functions of the automotive BCM: 1. Receives input information from sensors and converts the input information into signals that the microprocessor can receive; 2. After outputting execution commands, converts weak signals into execution commands and corrects them after outputting fault information; 3. Performs operational analysis, calculates execution command data based on information parameters, and compares the input information with standard values; 4. Stores, calculates, analyzes, and processes information, analyzes the programs used for output values, stores the characteristic parameters of the vehicle model, data during calculations, and fault information.
9
3
Share

Where is the Ford Transit cabin air filter located?

Ford Transit cabin air filter is located behind the glove box on the passenger side. To replace the cabin air filter, you need to remove the passenger side glove box - this is the only way to access and replace the filter. Below are the functions of the Ford Transit cabin air filter: 1. Ensures the filter fits tightly against the housing to prevent unfiltered air from entering the cabin. 2. Filters out solid impurities from the air such as dust, pollen, and abrasive particles. 3. Adsorbs moisture, soot, ozone, odors, carbon oxides, SO2, CO2, etc. from the air; has strong and lasting moisture adsorption capability. 4. Prevents windshield fogging to maintain clear visibility for safe driving; provides fresh air to the cabin to protect occupants from inhaling harmful gases; effectively sterilizes and deodorizes.
8
2
Share

What Causes Soft Brakes in Paladin?

Reasons for soft brakes in Paladin: Brake fluid contamination: If there is no brake fluid as the medium, or if the brake fluid's working performance is poor, it will result in insufficient friction between the brake pads and brake discs, leading to soft and ineffective braking. Air gap formation: Since brake fluid has certain hydrophilic properties, the longer the car is driven, the more water gets mixed in. After the water evaporates, an air gap forms between the brake pads and brake discs, causing soft and ineffective braking. Decreased reservoir fluid level: Each time the brake pedal is pressed, the fluid level in the brake fluid reservoir drops, and it rises again when the pedal is released. To ensure smooth fluid level changes, some vehicle models have vent holes in the reservoir cap (similar to the principle of vent holes in automatic transmissions, manual transmissions, and axles).
8
5
Share

What Causes the Skoda Octavia Dashboard Brake Light to Flash?

Skoda Octavia dashboard brake light flashing reasons are as follows: Low brake fluid: It is an essential part of the car's braking system. When the driver presses the brake pedal, the force is transmitted from the pedal to the brake master cylinder piston, through the brake fluid, to the brake calipers at each wheel, causing the brake pads to contact the wheels and stop the vehicle; add brake fluid. Tail light bulb failure: The brake fluid reservoir has upper and lower lines. When the brake fluid level falls below the lower line, the sensor next to the reservoir detects this and triggers the brake light on the dashboard. If the brake fluid level drops rapidly, it indicates a leak in the braking system; replace the bulb. Worn brake pads: Severely worn brake pads can also cause the light to stay on; replace the brake pads.
7
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.