How to Open the Trunk from Inside?

1 Answers
OLyla
07/29/25 4:50pm
To open the trunk from inside, follow these steps: Fold down the rear seats of the car, locate the trunk release handle, and pull it to open the trunk. Methods for trunk maintenance include: 1. Use a brush to clean dirt, including the edges and grooves of the trunk, and deodorize after cleaning; 2. Organize items with separate storage bags; 3. Lay a trunk mat to prevent dirt or liquids from entering and damaging the trunk surface, while also preventing items from sliding and reducing the risk of contamination or damage. Reasons why the trunk suddenly won't close include: 1. Foreign objects blocking the trunk latch; 2. Deformation due to damage to the trunk lock hook; 3. Broken wires in the flexible rubber tube.
Was this review help?
5
5
Share
More Forum Discussions

How to Remove the Wiper Arm?

First, fully lift the wiper to adjust the angle of the wiper blade. Next, change the angle of the wiper blade, preferably making it form a 90-degree angle with the wiper arm. Remove the entire wiper blade. With one hand, pull the rubber blade sideways, and with the other hand, firmly press down on the main bracket to separate the wiper blade from the arm.
17
4
Share

How to Determine if a Tricycle Motor is Damaged?

Take out the commonly used tool, a multimeter, set it to the 20v range, connect the red probe to the positive wire of the Hall sensor, and the black probe to the yellow, green, and blue wires of the Hall sensor respectively. Then turn on the power lock, slightly rotate the motor wheel, and observe the voltage changes. If the voltage changes, the corresponding Hall sensor is functioning normally.
6
5
Share

How to Deal with a Car Behind Honking Furiously?

Ignore it, drive normally and carefully, and remember not to get angry or impatient. On narrow roads with many pedestrians and electric bike riders, if the car behind is in a hurry, you can let it pass by moving aside, but always drive safely and yield to pedestrians at crosswalks.
4
0
Share

How to solve the VSA malfunction in Accord?

You can use an automotive diagnostic tool to access the system, check for any fault codes, and read relevant data information. When the VSA indicator light is on, it may indicate that the electronic stability control system is turned off. Simply press the switch to restart it. It could also mean there is a malfunction in the electronic stability control system, in which case you should take it to a repair facility for inspection and maintenance.
9
5
Share

How to correct left-wide and right-narrow when reversing into the garage?

When the rearview mirror shows a "left-wide and right-narrow" position relationship, turn the steering wheel 1/4 turn to the left, and straighten the wheel when the car body is aligned. When entering from the left, turn the steering wheel to the left in advance. If the left side is narrow, delay turning the steering wheel to the left. When entering from the right, delay turning the steering wheel to the right; if the left side is narrow, turn the steering wheel to the right in advance.
13
0
Share

How to Deal with Water Ingress in a Tricycle?

Check whether the motor coil is short-circuited, has paint peeling, or is corroded. Disassemble the motor for cleaning and drying. You can use thinner to wipe it or slowly remove the rust with a steel wire brush. Use a Hall tester or multimeter to test for damage to the Hall components. Replace the damaged ones, and note that beginners who are unsure can replace all of them.
8
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.