···
Log in / Register

How to Open the Rear Car Door?

3 Answers
StPenelope
07/29/25 4:50pm
To open the rear car door, follow these steps: 1. Use the car key to unlock the vehicle; 2. Hold the door handle and pull to open the door. Reasons and solutions for the rear car door not opening include: 1. The central locking system is activated. Use the car key to unlock and lock the vehicle twice, then locate the central locking button on the left front door trim of the driver's compartment and press the unlock button; 2. The child lock is activated. Turn the child lock to the off position; 3. The door lock cable is malfunctioning. Replace the door lock cable; 4. The door hinges or lock post are deformed. Adjust the door hinges and lock post; 5. The door limiter is malfunctioning. Replace the door limiter; 6. The door is frozen. Thaw the car using sunlight before attempting to open the door.
Was this review help?
16
5
Share
Gutierrez
08/14/25 6:39am
I often deal with car-related issues, and the method to open the rear door is actually quite simple: from inside the car, sit on the rear seat and directly pull the door handle—usually a vertical pull or an upward lift, which will release the door lock and open the door. If operating from outside, first use the key or remote to unlock the entire car, then pull the exterior door handle to enter; most modern cars use a remote button to unlock, while older cars might require a mechanical keyhole. Different car models have different designs—SUV rear doors might be higher, requiring you to stand on your toes, while sedan doors are lower, just bend down and pull. I also remind everyone to check if the child safety lock is turned off; it's located on the side edge of the door with a small switch. When locked, the door can only be opened from the outside, preventing children from accidentally opening it while the car is moving, which could be dangerous. Remember to regularly clean the door handles to prevent dust from jamming them, and always be mindful of the surroundings when opening the door to avoid hitting obstacles—safety should always come first.
Was this review help?
1
2
Share
Expand All
DonovanDella
10/13/25 3:32am
As someone who prioritizes family safety, I always exercise caution when opening the rear car doors: The interior method involves pulling the rear door handle to unlock directly, but I've made it a habit to activate the child safety lock feature—there's a toggle switch on the side of the door that, when engaged, disables the interior handle, allowing the door to be opened only from the outside. This significantly reduces the risk of children accidentally opening the door while the car is in motion. From the outside, first use the remote unlock or press the key fob button, then pull the external handle; after locking, always confirm that the doors are securely closed by listening for the audible click. In different weather conditions, such as rainy or icy days, open the door slowly with steady force to avoid slipping or the handle freezing. For maintenance, it's recommended to regularly check the lock mechanism for signs of aging and apply a small amount of lubricant. For theft prevention, always lock the doors after parking to minimize the risk of theft. Sharing these tips with fellow car owners can enhance daily driving peace of mind.
Was this review help?
17
3
Share
Expand All
More Forum Discussions

Should the Accord AC be ON or OFF?

The Accord AC should be set to ON for cooling and OFF for heating. Below is a brief introduction about the AC function: 1. AC: Stands for air-conditioning, which means air regulation. 2. The difference between using AC and not using AC is that one utilizes the air conditioning compressor while the other does not. Simply put, use AC for cooling in summer and turn it off in winter to utilize the radiator temperature for heating. 3. The A/C button controls the air conditioning. When the button's light is on, it means the compressor is working, which increases fuel consumption and is mainly used for cooling and blowing cold air.
3
1
Share

What is the autonomous driving level of the Huawei Arcfox Alpha S?

The Huawei Arcfox Alpha S has an autonomous driving level of L4. Here is some information about L4 autonomous driving: 1. L4 autonomous driving: Highly automated, still equipped with interfaces like a steering wheel to allow for manual control when necessary. 2. After activating autonomous driving, the computer will navigate its own route once the destination is set, requiring no intervention for full driving, except in specific areas like highways or urban zones. However, it can already handle most 'dynamic driving tasks.' Following the L4 autonomous driving phase, the technology is still in the development stage, and there are very few cars with L4 autonomous driving technology available on the market.
4
2
Share

Why does the Highlander display show 'battery charging'?

The Highlander display showing 'battery charging' may occur due to the following reasons: 1. Insufficient driving time leading to incomplete battery charging. 2. Using power-consuming devices like navigation, music system, or air conditioning after starting the vehicle. 3. Continuous operation of the engine start-stop technology - when braking, if the battery isn't fully charged, the engine keeps running to charge instead of shutting off. In this case, since the start-stop system is active, the display will show the start-stop indicator along with the 'charging' notification to inform the driver that the vehicle isn't in start-stop mode because the battery is being charged.
19
3
Share

Where is the OBD port located on the Citroen C4?

The OBD port on the Citroen C4L is located at the bottom of the center console, just above the USB port. Here is some information about the OBD port: 1. OBD stands for On-Board Diagnostics. 2. The OBD system monitors multiple systems and components, including the engine, catalytic converter, particulate filter, oxygen sensors, emission control system, fuel system, EGR, etc. 3. When an emission-related fault occurs, the ECU records the fault information and related codes, and alerts the driver by illuminating the malfunction indicator lamp.
14
5
Share

How to bleed the electric water pump on a Volvo XC60?

The bleeding method for the Volvo XC60 electric water pump is as follows: 1. During filling, open the bleed screw of the auxiliary water tank, the coolant evaporator, and the transmission coolant vent screw until no bubbles are visible, then tighten them to enter the bleeding phase. 2. Connect the charger, turn the ignition switch to the second position, set the air conditioning fan to the lowest setting, adjust the temperature to the maximum, turn on the low beam headlights, and press the accelerator pedal for about ten seconds. You will then hear the sound of water being expelled from the auxiliary water tank. The water pump will run for a while to expel the air from the engine. 3. Note: Bleeding the electric water pump must be performed when the engine is in a cold state.
14
4
Share

What are the differences between Civic and Lamando?

Civic and Lamando mainly have the following differences: 1. Exterior: Lamando continues the design language of the Volkswagen family, with a flat front grille and a wide-body design that gives the Lamando an overall wide and flat impression; while the Civic follows Honda's family-style design, with a youthful, vibrant, and sporty appearance that appeals to many consumers. 2. Interior: The interior quality of the Civic is slightly inferior to that of the Lamando, and the plastic feel of the dashboard is a point of dissatisfaction for many, although its dashboard design still has a sporty touch.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.