···
Log in / Register

How to Open the Lavida Trunk?

4 Answers
BrooklynLynn
07/29/25 10:34am
Methods to open the Lavida trunk: 1. There is a button located below the trunk lid and between the license plate lights, which can be used to open the trunk; 2. On the inner panel of the driver's door, there is a trunk release button—pull it upward to open the trunk; 3. Use the key to open the trunk. The key has a trunk release button in the middle—press and hold it for about 2-3 seconds to open the trunk. The Lavida is a sedan produced by SAIC Volkswagen, with body dimensions of 4605mm in length, 1765mm in width, and 1460mm in height, a wheelbase of 2610mm, and a top speed of 200 km/h.
Was this review help?
19
4
Share
AlanLynn
08/13/25 2:57pm
As a Lavida owner, opening the trunk is something I do frequently—simple and effortless. My car is the 2020 model, equipped with a standard remote key. Just press the trunk button on the key (usually marked with a luggage icon), and it works from a distance of five to six meters. It’s even more convenient when sitting inside the car—there’s a dedicated button on the driver’s side door panel. A quick press, and the trunk pops open. For older models, like those before 2015, the trunk might only be opened via the key button or a manual lock. Safety-wise, it’s important not to operate it while driving to avoid unexpected situations. During maintenance, cleaning the button contacts to prevent dust buildup can extend their lifespan. Once, during heavy rain when the door lock malfunctioned, I easily opened the trunk using the interior button—super handy. Overall, the Lavida’s design is thoughtful, with slight variations across model years, but after a few tries, it becomes second nature.
Was this review help?
8
5
Share
Expand All
OTessa
10/07/25 5:44am
The trunk opening of the Lavida is quite straightforward, based on an electronic control system. The key button sends a signal to the vehicle control module to trigger the latch release, while the interior switch is located near the left front door—simply press it gently to operate. If the trunk fails to open, the most common issue is a blown fuse, located in the engine compartment fuse box; locate the corresponding marking to inspect and replace it. A mechanical backup method involves inserting the key into the trunk lock cylinder and turning it, which is practical during electronic failures. Daily system maintenance is simple: avoid repeatedly pressing the buttons excessively to reduce wear, and ensure stable voltage for normal power supply. I recommend opting for the automatic sensor opening feature in newer models for added convenience. Overall, the system is highly reliable, but regular functional testing is essential to prevent unexpected issues.
Was this review help?
15
4
Share
Expand All
HavenAnn
11/20/25 7:08am
Opening the trunk is a routine task for me. The remote key opens it with a single click, and the in-car button is conveniently placed. Young car owners appreciate this one-touch design for saving time and effort without straining their hands. Occasionally, if there's an electronic glitch, the emergency trunk release cord inside the car solves the problem—Lavida is quite considerate in this aspect. Modern car models integrate technology seamlessly into daily life, offering smooth operation that requires no second thought, allowing drivers to focus more on driving with peace of mind. Just be mindful of safety by preventing children from randomly pressing buttons and causing trouble. Overall, the experience is simple, user-friendly, and stylish.
Was this review help?
3
0
Share
Expand All
More Forum Discussions

How often should a sedan be driven at minimum?

It is recommended to drive a sedan at least once a month and run the engine for over half an hour. Precautions for long-term parking of vehicles include: 1. Clean and maintain the vehicle before parking; 2. Park the car in a garage or choose a dry and shaded area whenever possible; 3. Regularly check tire pressure and inflate promptly when insufficient, while also monitoring tire aging; 4. Thoroughly inspect items inside the car before parking, ensuring no food, beverages, or food packaging waste is left behind. The impacts of prolonged vehicle parking are: 1. Premature failure and aging of oil seals, leading to oil leaks; 2. Shortened battery lifespan; 3. Tire deformation due to prolonged pressure on contact areas; 4. Malfunctions in electronic components; 5. Oil oxidation corroding mechanical parts; 6. Aging of the braking system.
5
2
Share

What to Do If a Small Amount of Paint is Scratched Off the Car?

If a small amount of paint is scratched off the car, you can use a touch-up pen or perform a touch-up. The steps for touch-up are as follows: 1. Thoroughly clean the surface to be repaired before starting; 2. Use alcohol to remove wax, moisture, oil, and rust from the area to be repaired to enhance the adhesion of the paint film; 3. Shake the touch-up pen vigorously before use, hearing the sound of the mixing ball for at least 30 shakes; 4. Open the cap of the touch-up pen in an upright position to avoid paint spillage; 5. For deeper scratches, apply the paint repeatedly with the brush; 6. The area touched up with the pen may be slightly uneven. After the paint film dries, use 2000-grit wet sandpaper to smooth it until the surface is level with the surrounding area.
3
4
Share

How to Turn on the High Beam in a Civic?

The method to turn on the high beam in a Civic is: 1. Enter the vehicle and locate the light control lever; 2. Push the lever forward for high beam, and pull it backward for a single high beam flash. Usage of Civic's light control positions: 1. Turn the left knob to the 'off' position to turn off the lights; 2. Turn the left knob to the middle position to turn on the parking lights; 3. Turn the left knob to the lower position to turn on the low beam; 4. Use the middle knob to control the fog lights; 5. Push the lever upward for the right turn signal, and downward for the left turn signal. Adjust the Civic's light positions according to actual driving conditions and needs to ensure driving safety.
12
4
Share

How to reset the maintenance light on the Bora 1.6?

The maintenance light on the Bora 1.6 cannot be reset manually. Resetting requires the use of a specialized diagnostic tool. The first maintenance is preset by the manufacturer, and after the first maintenance, the 4S shop will set the reminder for the next maintenance. The Bora is a model under FAW-Volkswagen, with body dimensions of 4523mm in length, 1775mm in width, and 1467mm in height, and a wheelbase of 2610mm. In terms of appearance, the front design of the Bora incorporates Volkswagen's design language, integrating streamlined lines into the front design. Precise and bold lines connect the headlights with the chrome-plated grille. The contour lines of the headlights are precisely matched with the internal styling lines and complement the chrome grille, forming Volkswagen's signature front face.
14
5
Share

How to Properly Start a Geely Boyue Automatic Transmission?

To properly start a Geely Boyue automatic transmission, ensure the vehicle is stationary, depress the clutch pedal, and press the start button. Taking the 2021 Geely Boyue as an example, its body dimensions are: length 4519mm, width 1831mm, height 1694mm, with a wheelbase of 2670mm, fuel tank capacity of 58 liters, and curb weight of 1575kg. The 2021 Geely Boyue features a MacPherson strut independent front suspension and a multi-link non-independent rear suspension. It is equipped with a 1.8L turbocharged engine, delivering a maximum horsepower of 163PS, maximum power of 120kW, and maximum torque of 250Nm, paired with a 6-speed manual transmission.
17
3
Share

What is the role of the planetary gear mechanism in an automatic transmission?

The role of the planetary gear mechanism in an automatic transmission is: 1. To use clutches and brakes to change the relative motion relationships of the components within the planetary gear mechanism; 2. To achieve different gear transmissions, altering the transmission ratio and direction. The planetary gear mechanism consists of a sun gear, ring gear, planetary carrier, and planet gears. The working principles of the planetary gear mechanism are: 1. Power is input from the sun gear and output from the ring gear, with the planetary carrier locked by the mechanism; 2. Power is input from the sun gear and output from the planetary carrier, with the ring gear locked; 3. Power is input from the planetary carrier and output from the sun gear, with the ring gear locked; 4. Power is input from the planetary carrier and output from the ring gear, with the sun gear locked.
4
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.