How to Open the Hood of Volkswagen Lavida XR?
3 Answers
To open the hood of the Volkswagen Lavida XR: 1. Pull the hood release handle located near the driver's knee area, and the hood will automatically pop up slightly; 2. If there is no gap, press down on the hood slightly to release it. The Volkswagen Lavida XR has the following dimensions: length 4445mm, width 1765mm, height 1485mm, with a wheelbase of 2610mm, a fuel tank capacity of 55 liters, and a curb weight of 1290kg. The front suspension is a MacPherson strut independent suspension, and the rear suspension is a torsion beam non-independent suspension. It is equipped with a 1.4L turbocharged engine producing a maximum horsepower of 110ps, maximum power of 81kW, maximum torque of 200Nm, paired with a 7-speed dual-clutch transmission.
I remember the first time I tried to open the hood of my Volkswagen Lavida, I was completely clueless. Later, I figured out it's actually quite simple. Open the driver's door, look down near your left foot, and you'll find a small lever. Pull it, and you'll hear a click as the hood pops open. Then, walk to the front of the car, and in the gap right above the logo, you can feel a small latch switch. Push this small metal latch to the right, and once you feel the latch loosen, immediately lift the hood. Inside the front of the car, there's a black support rod—insert it into the corresponding hole on the hood to secure it. Remember not to stand too close to avoid pinching your hands, as the hood is heavier than you might expect. In winter, wear gloves when doing this, as the metal parts can be hard to move when frozen.
As a seasoned driver who frequently operates this vehicle, opening the hood is a two-step process. First, sit in the driver's seat, bend down, and pull the small loop with the engine emblem located at the lower left side. Apply some force until you hear a click, indicating the hood has popped open. Then, exit the vehicle and walk to the front of the car. Insert your right hand into the center gap of the hood to feel the protruding safety latch. Pinch it with your fingers and slide it parallel to the right side of the vehicle while simultaneously lifting the hood with your left hand. The support rod is located on the left side of the engine compartment; simply pull it out and insert it into the metal base of the hood. Note that the safety latch is designed for manual unlocking to prevent accidental opening while driving.
