How to Open the Hood of Toyota C-HR?
4 Answers
The method to open the hood of Toyota C-HR is: 1. Press the hood release switch located on the instrument panel to the left of the steering wheel; 2. The hood will pop up slightly, revealing a gap. Insert your hand into the gap; 3. Release the hood latch underneath and lift the hood upwards. The Toyota C-HR is a compact SUV. Taking the Toyota C-HR 2020 Elite Edition as an example, its body dimensions are: length 4405 mm, width 1795 mm, height 1565 mm, with a wheelbase of 2640 mm. The Toyota C-HR 2020 Elite Edition is equipped with a 2.0L naturally aspirated inline 4-cylinder engine, delivering a maximum horsepower of 171 hp and a maximum power output of 126 kW at 6600 rpm. It is paired with a 10-speed continuously variable transmission.
I've been driving the Toyota C-HR for over three years, and opening the hood is really simple. The first step is to sit in the driver's seat. There's a small lever near your left foot, usually marked with an engine icon. Gently pull it, and you'll hear a click as the hood pops open slightly. Then, get out of the car and walk to the front. Feel under the center of the hood's front edge for a small lever or button. Press it while slowly lifting the hood, then secure it with the support rod. Remember, before operating, you must park the car, turn off the engine, and engage the handbrake to avoid accidents. I open the hood every week to check the oil and coolant, keeping the car healthy and saving trips to the repair shop. If you're a beginner and unfamiliar with the process, check the user manual first—don’t force it open and risk damaging the hinges.
I'm the kind of person who enjoys DIY, and I find opening the hood of my Toyota C-HR quite interesting. Once inside the car, locate the release lever near the steering wheel and pull it to disengage the latch. Then, move to the front of the car, crouch down slightly, press the safety catch, and simultaneously push the hood upward. Make sure the support rod is securely in place to prevent it from slamming down on your hands. I often DIY checks on the battery and filters, and I find this design very user-friendly. If it gets stuck, avoid using excessive force—check if the cable is loose. Wearing gloves during the operation provides extra safety for your fingers. The whole process takes about two minutes, much easier than expected.
When I first started driving the Toyota C-HR, I was afraid to touch the hood, worried I might do it wrong. Later, I learned it's quite simple: sit firmly in the car, find a small lever near the left foot area, and pull it. The hood will make a sound. Then, get out of the car, feel for a latch under the middle front of the car, press it, and then lift the hood. Make sure the car is parked on level ground and turned off before doing this. It's not complicated and can be learned in one go.
