How to open the hood of the Leiling?

[SanMelanie]

The method to open the hood of the Leiling: First, locate the hood release lever on the left side of the driver's compartment near the door pillar. Pull the lever, and you will hear a click from the front. Then, go to the front of the car, and you will see a gap of about 1cm between the hood and the body. With one hand lifting the hood, use the other hand to reach in from the top of the grille and pull the hood release latch. Then, push the hood up and secure it with the support rod. The Leiling Hybrid version is equipped with a hybrid system consisting of a 1.8L Atkinson cycle engine and an electric motor. The engine has a maximum output of 99 horsepower, while the electric motor delivers a maximum of 72 horsepower. The exterior features a bolder chrome trim on the grille that integrates seamlessly with the new LED headlights. The front fascia's large grille has been adjusted in size and is now outlined with a trapezoidal trim.

[ElijahAnn]

I've been driving a Levin for several years, and the hood release is particularly easy to find near the left foot position. First, sit in the driver's seat and look down at the bottom left corner of the dashboard—there's a plastic handle with an engine icon. Grab it and pull firmly toward you until you hear a 'pop' from the front. The hood will then pop up slightly. Walk to the front center of the car, slide your fingers into the gap, and feel for a movable lever. While pushing it to the left with your right hand, use your left hand to lift the hood—it's a bit heavy, so apply some force to raise it fully. Then, reach inside with your right hand, pull out the silver support rod, and secure it into the triangular slot on the hood. Remember to turn off the engine and engage the parking brake before operating. Be cautious as some metal parts may be hot if the car has just completed a long drive. After opening, don’t forget to check the coolant and windshield washer fluid—these minor tasks can be handled easily during routine maintenance.

[StTravis]

New drivers, don't worry about opening the Levin's hood—just follow these three steps: First, locate the release lever on the lower left side of the steering wheel, marked by a raised engine symbol. Pull it firmly for about two seconds until you hear an unlocking sound. Then, move to the front center of the car, where you'll need to push the movable metal tab upward at an angle with your thumb while lifting the hood panel. Wearing gloves is recommended as edges may be dirty. The support rod might feel stiff initially—use your knee to gently prop the hood open for leverage. Before each maintenance, check the engine bay for debris, as accumulated leaves can block drainage holes.

[RonanLee]

The Levin's hood features a dual-safety design. The first latch is located at the pull handle in the lower left corner of the driver's seat. After pulling it, the hood will pop open slightly but won't fully release – you'll need to address the second safety mechanism at the front of the car. I usually stand directly in front of the emblem, steadying the Toyota logo with my left hand while reaching into the gap with my right hand to locate the spring-loaded latch. The key is to use your palm to push the silver metal plate all the way flat before lifting the hood – trying to pry it open directly may cause it to jam. When raising the hood to its highest point, don't let go immediately; first secure the U-shaped support rod and then organize the wiring channel. Remember to clean the hood gap during regular car washes, as gravel can wear down the sealing strip.

[Lamar]

Familiarize with the location before opening the Levin's hood: There's a black plastic handle on the left side of the driver's seat, vertically positioned against the floor. Pull it decisively—being too gentle may fail to release the first latch. The hood unlocking trick is to locate the raised point in the middle of the lock plate and push its side with your fingertip while lifting the hood upward. The metal support rod is near the radiator; when removing it, be cautious to avoid the fan area. The hood is quite heavy, so shorter individuals may tiptoe and use their shoulder to lift it before hooking. The engine compartment is tightly arranged, so avoid touching the red battery terminals after opening. Regularly wiping the engine guard plate can prevent rust.

[Jennifer]

Precautions for operating the Leiling hood: First, pull the interior release lever located at knee height below the steering column on the left side. When pulled sufficiently, you'll hear a click, and the hood will pop up with about a 5 cm gap. Before reaching in, crouch down to locate the silver movable latch inside the gap—push it sideways with your fingertips until it's fully engaged, then lift the hood from underneath. The support rod slot is at the front inner edge of the hood; ensure you hear a click when inserting it for proper installation. If you have less strength (e.g., female users), use your right hand to hold the hood while quickly securing the rod with your left. Starting the vehicle with the hood open triggers an alarm, so keep the car door open throughout the process for easy access.