How to open the hood of Chery EQ1?

How to Reset the Mileage on Volkswagen Lavida?

Methods to reset the mileage on Volkswagen Lavida: 1. Turn on the ignition switch and press the reset button on the right side of the instrument panel to toggle between the total mileage counter and the trip mileage counter; 2. Confirm which mileage counter you want to display on the screen as needed; 3. After the trip mileage appears, if you press and hold the reset button, the trip mileage counter will be reset to zero. The Volkswagen Lavida is a compact 4-door, 5-seater sedan with dimensions of 4670mm in length, 1806mm in width, and 1474mm in height, and a wheelbase of 2688mm. In terms of power, the Lavida is equipped with a 1.4T turbocharged engine and a 7-speed dual-clutch transmission, delivering a maximum power of 110 kW and a maximum torque of 250 Nm.

3

5

Share

How to Determine if the Generator is Faulty?

To determine whether the generator is faulty, follow these steps: Start the engine to keep the generator running and use a multimeter to measure the battery voltage. At this time, the battery voltage should be between 13-14.8V, indicating that the generator is in good condition; if the battery voltage remains unchanged after turning off the engine and stopping the generator, it indicates a problem with the generator. Relevant information about the car generator is as follows: 1. Introduction: The car generator is the main power source of the vehicle. Its function is to supply power to all electrical equipment (except the starter) while the engine is running normally, and simultaneously charge the battery. 2. Structure: Based on the three-phase stator winding of a conventional AC generator, the number of winding turns is increased, and lead-out terminals are added, along with an additional three-phase bridge rectifier. At low speeds, the output is provided by the original winding and the additional winding in series, while at higher speeds, only the original three-phase winding provides the output.

14

2

Share

What are the reasons why a car cannot run?

The reasons why a car cannot run: 1. The ignition timing advance angle of the cylinder is inaccurate; 2. The spark plugs are not working or there is a cylinder misfire; 3. The fuel supply system is not smooth or blocked, and the fuel pump has an air leak; 4. The clutch engagement is incomplete or the clutch has damaged rivets causing eccentric engagement; 5. The engine crankshaft clearance is too large; 6. The clearance between the output shaft and the differential is too large or damaged; 7. Check for any cracking or backfiring sounds. If present, it indicates the air-fuel mixture ratio is too rich or too lean, and the mixture ratio should be adjusted; 8. The fuel injectors are too dirty or the carburetor is too dirty. For fuel-injected cars, clean the injectors. For carbureted cars, disassemble and clean the carburetor and adjust the fuel level.

7

1

Share

How to Identify a Stock Car?

Methods to identify a stock car include: 1. Check the vehicle identification plate; 2. Inspect tire wear and manufacturing date; 3. Examine the cleanliness of the exhaust pipe inner wall; 4. Look for dust in the engine compartment, check for deformation or discoloration of components, their alignment, and any signs of removal; 5. Inspect the vehicle's rubber parts for aging or detachment; 6. Check the foot pedals for wear or excessive dust in the gaps; 7. Ensure the paint on the lower edge of the door frame is intact. A stock car refers to a vehicle that has remained unsold for over 6 months in inventory, and such cars should undergo regular cleaning, maintenance, and battery charging.

19

1

Share

How to Adjust the Time on a 2010 Teana?

2010 Teana time adjustment method: After turning on, the CLK button displays and sets the time. Press and hold CLK for about 5 seconds until the time display flashes on the screen. Use the adjustment knob (turn left to decrease, turn right to increase) to set the time, then press CLK to confirm. Here is some related information: 1. The Teana's body dimensions have been lengthened and widened. With a body length of 4901mm, it appears very sleek with the rear styling and waistline. 2. The 8-inch LCD display on the center console is large enough, but the display quality doesn't look premium. The interface design is relatively simple and clearly layered, making it easy to use even for first-time users. Functionally, it offers rich multimedia playback features and connectivity applications, including in-car apps, in-car WiFi, and common internet functions, but it does not support CarPlay.

16

5

Share

Can the BYD F3 be used for Didi ride-hailing?

The BYD F3 can be used for Didi Express. The application requirements are as follows: 1. License plate requirements: The joining driver must own their own car with a local license plate. Additionally, the car must have a base price of over 70,000 RMB and be less than 8 years old. 2. Driving experience: The joining driver must possess a C1 or higher driver's license with at least 3 years of driving experience, be between 22 and 60 years old, and drive a vehicle that matches their permitted driving category when joining. 3. Personal requirements: The joining driver must hold an ID card, vehicle registration certificate, and driver's license simultaneously, have no bad records or criminal history, be in good health, capable of fulfilling duties, and have a strong sense of responsibility.

15

4

Share

How to open the hood of Chery EQ1?

How to Reset the Mileage on Volkswagen Lavida?

How to Determine if the Generator is Faulty?

What are the reasons why a car cannot run?

How to Identify a Stock Car?

How to Adjust the Time on a 2010 Teana?

Can the BYD F3 be used for Didi ride-hailing?

How to Determine the Position of the Wheels While Driving?

How to Replace the Battery of a Bestune B30 Car Key?

Can the Car Air Filter Be Installed Both Ways?

How to adjust the time on the Besturn B50?