How to Open the Hood of an Older Teana Model?
2 Answers
The method to open the hood of an older Teana model is as follows: The hood release switch is located on the left side below the steering wheel inside the cabin. Pull the release button upward, and the hood will pop up slightly, allowing you to lift it. Then, move to the front of the hood, reach inside, and pull the latch upward to fully open the hood. The Teana is a mid-to-high-end luxury sedan under the NISSAN brand, with body dimensions of 4850mm in length, 1795mm in width, and 1475mm in height, and a wheelbase of 2775mm. The front suspension is MacPherson strut type, and the rear is multi-link. In terms of safety features, the Teana is equipped with a series of configurations including VDC (Vehicle Dynamic Control) system, TCS (Traction Control System), ITS (Intelligent Trace Control) system, AVM (Around View Monitor) system, HSA (Hill Start Assist) system, and TPMS (Tire Pressure Monitoring System).
I remember opening the hood on the old Teana was quite straightforward, just a two-step process. First, sit in the driver's seat, bend down, and locate a small lever on the left side below the steering wheel—that's the hood release lever. Give it a firm pull, and you'll hear an unlocking sound, indicating the first step is done. Then, get out of the car and walk to the front. You'll notice the hood edge slightly popped open with a small gap. Slide your fingers into the gap and feel for the safety latch, usually a yellow or metallic button positioned toward the center-right. Gently push it to the left or flip it upward, and the hood will lift smoothly. On older cars, this latch can get stuck or rusty, so applying lubricant grease periodically helps prevent issues. Once open, don’t forget to secure the support rod properly to avoid accidental drops that could hurt your hands. It’s a good habit to check the engine oil level and coolant whenever you open the hood—this helps spot potential problems early for a worry-free drive. If it feels stiff on your first try, don’t force it; consult the user manual or ask for assistance.
