How to Open the Hood of a Toyota Levin?
3 Answers
Toyota Levin hood opening method: There is a release handle under the instrument panel on the lower left side of the driver's seat. After pulling it, the hood will pop up about 1cm. Lift the hood with one hand while reaching inside the grille with the other hand to locate the hood release lever. Detailed information as follows: 1. The Levin hood is made of rubber foam and aluminum foil materials, which reduce engine noise while isolating heat generated by the engine, effectively protecting the hood's paint surface and preventing aging. 2. The Levin is a compact sedan with body dimensions of 4640mm in length, 1780mm in width, and 1455mm in height, with a wheelbase of 2700mm.
Opening the hood of a Toyota Levin is actually quite simple. Let me share my own method. You need to sit in the driver's seat, close the door, turn off the engine, and make sure the car is parked on level ground for safety. Then, look down towards your left foot—there's a small lever or button under the dashboard with a hood icon on it. Just give it a gentle pull. Don't rush to get up after pulling it; wait until you hear a 'click' sound, which means it's unlocked. Then, go to the front of the car, and near the middle bottom of the hood, there's a small latch or button. Reach in and push it up or press it, and the hood will pop open slightly. Next, lift the hood with your hand and secure it with the support rod to keep it steady. I usually use this method to check the engine oil or coolant to ensure the car is in good condition, avoiding any issues on the road. Learning these little tricks is great for car maintenance.
To open the hood, start inside the cabin. After getting into the Leiling, look to the lower left of the steering wheel for the hood release lever. Pull it twice until you feel it loosen. Then, exit the vehicle and move to the front. Near the emblem, there's a small unlock lever hidden in the hood gap—push it up to lift the hood. Secure the support rod properly to prevent accidental closure. I make it a habit to do this before every maintenance check—it's simple and helps with checking fluid levels or cleaning radiator dust to keep the car running smoothly. Remember not to operate when the engine is hot to avoid burns. This two-step process from inside to outside becomes familiar with a few practices.
