How to open the hood of a Besturn B50?
4 Answers
The method to open the hood of a Besturn B50 is: 1. Enter the driver's seat and locate the hood release lever on the left side below; 2. Lift the hood release lever upwards to pop open the front hood; 3. Lift the hood and secure the support rod in place. The hood is made of rubber foam and aluminum foil materials, which not only reduces engine noise but also isolates the heat generated during engine operation. The Besturn B50 has dimensions of 4615mm in length, 1785mm in width, and 1435mm in height, with a wheelbase of 2675mm. It is equipped with a cornering light system, and both AUX and USB interfaces for dual external audio source playback functions.
I remember when I drove the Besturn B50, the hood release lever was right under the dashboard near my left foot – just bend down and you'd see a small handle with the car's front emblem. Give it a firm pull downward, and you'd hear a 'click' as the hood popped open slightly at the front. But don't walk away yet, because there's a secondary safety latch! You'd need to go around to the front, reach into the gap at the center of the hood, and find a small yellow lever hidden inside. Flick it to the left with your finger, then lift the hood up. The support rod is attached to the underside of the hood – just pull it up and slot it into the hole. This is what you'd use for topping up windshield washer fluid or checking the engine oil, but beginners should remember to turn off the engine and let it cool for half an hour first to avoid getting burned.
The first time I figured out how to open the hood was in a parking lot. Squatting down, I noticed a plastic handle above the driver's left foot with a front car graphic printed on it. Pulling it firmly all the way down caused the hood to pop up slightly. The crucial step then was locating the safety latch underneath the hood, about five centimeters behind the car emblem. I would simply reach in to feel for a movable metal tab and push it toward the driver's seat. Finally, with both hands supporting the upper edge of the hood, I'd lift it forcefully until hearing a 'click,' indicating the support rod had automatically locked into place. It's advisable to do this when the engine is cold to avoid burning your hands. Always ensure the support rod is securely locked—last time, it nearly slammed down on my fingers.
Locate the hood release lever icon under the steering wheel on the driver's side and pull it to pop the front hood open slightly. Here's the crucial part—you must release the secondary latch! I usually stand in front of the car, bend over, and use my right hand to reach about 2-3 cm into the center gap of the hood to feel for a springy metal tab. Push it to the right while lifting the hood with my left hand. The whole process takes about 10 seconds. Remember to do this after turning off the engine. If you try to force the hood open without releasing the secondary latch, you might not open it at best, or break the lever at worst. The support rod is on the inner side of the hood panel above the left wheel.
