···
Log in / Register

How to Open the Fuel Tank Cap of the Sylphy?

3 Answers
JakeAnn
07/29/25 12:34am
The method to open the fuel tank cap of the Sylphy is: The fuel tank cap switch is located at the bottom left of the instrument panel, near the driver's knee when seated. Gently pull the switch to open it. The Sylphy is a compact sedan with a maximum engine horsepower of 135 HP and a maximum torque of 159 Nm, equipped with a CVT continuously variable transmission. The Sylphy's dimensions are 4641mm in length, 1815mm in width, and 1450mm in height, with a wheelbase of 2712mm. Its top speed is 186 km/h, and the fuel tank capacity is 47L. The car features front-wheel drive, with a front McPherson independent suspension and a rear torsion beam non-independent suspension.
Was this review help?
4
4
Share
Tanner
08/11/25 10:07am
I used to frequently help people repair cars like the Sylphy, and the method to open the fuel tank cap is quite intuitive. Usually, after unlocking the doors, you simply press the outer edge of the fuel tank cap, and it pops open—designed to be simple and effortless. The pressing point is at the center of the cap, and the force should be moderate; pressing too hard may damage the plastic clips. I’ve seen many owners struggle because the doors were locked without unlocking the key area. The procedure is mostly the same across different model years of the Sylphy, though older versions might have slight differences—check the manual if unsure. Safety tip: Always turn off the engine before refueling. If the cap won’t open, don’t force it. Keep the area clean to prevent clogging. In winter, if frozen, wait a few minutes for it to warm up before trying again. Regular maintenance should include checking the cap’s sealing ring for damage, as oil leaks pose serious risks. In short, gentle operation and familiarity make it easy.
Was this review help?
19
2
Share
Expand All
StTravis
10/01/25 7:41am
I'm a huge fan of the Sylphy and have driven several generations. The fuel tank cap opening mechanism is super simple. After unlocking the doors, locate the fuel tank cap position at the rear of the car, and it opens with just a press—quick and stylish. This push-button design is quite common in Nissan vehicles, offering convenience and efficiency without delays. Always remember to turn off the engine when refueling to prevent risks, and check for debris or water droplets before opening the cap. If it doesn't open when pressed, check if the key is in the sensing area or replace the battery. There might be slight variations depending on the Sylphy model, but most follow the same method. Over time, it becomes a habit: clean around the cap whenever you open it to make maintenance easier. When replacing parts, ensure they match the model specifications and avoid cheap, low-quality products. The Sylphy excels as a family car, with these thoughtful little details helping to keep it in top condition.
Was this review help?
3
4
Share
Expand All
More Forum Discussions

Can You Still Drive When the Oil Life is 0?

When the oil life reaches 0, it is not recommended to continue driving. Here is some extended information about oil life: 1. The vehicle's computer alerts you about oil life based on preset mileage. 2. If the oil life displays as 0, check whether it is due to a data error caused by not resetting after an oil change or prolonged disuse of the oil. 3. Engine oil has a shelf life and cannot be used indefinitely. The shelf life of oil depends on its condition. Unopened engine oil can last up to five years; leftover oil after a car service, being opened, has a shortened shelf life of about one year; oil already poured into the engine has the shortest shelf life, approximately six months. 4. While checking the car's oil, you can use an oil inspection filter paper to test if the oil has deteriorated. By dripping oil onto the filter paper, three important ring-shaped areas can be observed: the deposit ring, the diffusion ring, and the outer oil ring, which indicate the oil's contamination level, the dispersing ability of additives against contaminants, and the oil's oxidation level.
14
1
Share

What are the causes of brake noise after vehicle startup?

Vehicle startup after the brake noise causes are: 1, too slow to release the brake caused; 2, the new replacement of the brake pads running-in is not in place; 3, sand particles into the middle of the brake pads and brake discs; 4, the brake disc fixing screws are lost or damaged; 5, the brake system failure. The brake maintenance methods are: 1, high temperature protection, to prevent the brake system corrosion, to prevent the brake pads due to high temperature surface bite, to eliminate the brake pads scream; 2, regular replacement of brake oil; 3, clean the brake discs, brake drums and any parts of the oil stains, dirt and friction dust, to maintain the brake disc heat dissipation good; 4, regular inspection of the thickness of the brake pads or brake shoes.
13
0
Share

What Causes the Brake Pedal to Be Hard to Press and the Car Unable to Start?

Here are the reasons why the brake pedal is hard to press and the car cannot start: 1. Vacuum booster pump leakage: If the car's vacuum booster pump leaks or malfunctions, the force required to press the brake pedal increases because the brake booster is not functioning properly. If it fails, the brake loses its power assistance, making it difficult to press. 2. Normal phenomenon: The inability to press the brake pedal after the engine is turned off is related to the brake booster pump. The brake booster pump only continuously generates vacuum when the engine is running. When the engine is off, it relies on the remaining vacuum assistance, but this will restore once the engine starts, and it is not a malfunction. Additional info: In driving, to prevent unexpected situations like sudden movement or rolling when starting the car, automatic transmission models are designed to require pressing the brake pedal to start. If the brake pedal is not pressed, the car will not start successfully. Moreover, the gear must be in P (Park) or N (Neutral) when starting an automatic transmission car. If started in N without the handbrake engaged, the car may roll. Therefore, the "press brake to start" design is entirely for safety considerations.
13
2
Share

Is Brake Maintenance Necessary?

Brake maintenance is necessary. Only by timely servicing the components of the brake system and cleaning and lubricating the safety parts can the accuracy and safety of the brakes be ensured. Below are the phenomena that may occur if the brake system is not maintained for a long time: 1. Abnormal noise: The dust from normal wear of the brake pads accumulates near the brake calipers, and if not cleaned for a long time, it can cause abnormal noise; the sound-damping and vibration-damping plates of the brake pads, if not cleaned and lubricated for a long time, can also cause brake noise. 2. Abnormal wear: When driving on gravel roads, some particles may splash between the brake pads and brake discs, causing noise or abnormal wear. 3. Brake deviation: If the dust cover of the sliding shaft of the caliper is damaged, driving through water or mud puddles can cause the caliper shaft to rust and seize, the caliper to not return to position, reduced braking force, and brake deviation.
14
1
Share

What engine does the Peugeot 5008 have?

The Peugeot 5008 is equipped with 1.6T and 1.8T turbocharged engines. A turbocharged engine refers to an engine fitted with a turbocharger. Taking the 2019 Peugeot 5008 as an example, it is a mid-size SUV with the following dimensions: length 4670mm, width 1855mm, height 1650mm, wheelbase 2840mm, and curb weight 1541kg. The 2019 Peugeot 5008 features a MacPherson strut front suspension and a torsion beam rear suspension. It is powered by a 1.6T turbocharged engine producing a maximum horsepower of 170PS, maximum power of 125kW, and maximum torque of 250Nm.
7
5
Share

What engine does the Buick Regal use?

Buick Regal uses a 1.5T turbocharged engine and a 2.0T turbocharged engine. A turbocharged engine refers to an engine equipped with a turbocharger. Taking the 2020 Buick Regal as an example, it belongs to the mid-size car category with a length of 4904mm, width of 1863mm, height of 1461mm, wheelbase of 2829mm, fuel tank capacity of 55L, and trunk capacity of 441L. The 2020 Buick Regal is equipped with a 1.5T turbocharged engine, delivering a maximum horsepower of 169PS, maximum power of 124kW, maximum torque of 250Nm, and is paired with a 9-speed automatic manual transmission.
1
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.