How to Open the Engine Hood of a Lavida Car?
2 Answers
Lavida's engine hood switch is located on the left side below the steering wheel in the cockpit. First, pull the release lever upwards; at this point, the engine hood can be lifted slightly to reveal a small gap. Move to the front of the engine hood, reach inside, and pull the latch upwards to fully open the hood. Below is some relevant information about the Lavida: 1. The Lavida (LAVIDA) is an A-segment car independently developed by Shanghai Volkswagen. 2. The car measures 4605mm in length, 1765mm in width, and 1460mm in height, with a wheelbase of 2610mm. In terms of power, the Volkswagen Lavida is equipped with a 1.6L inline four-cylinder multi-point fuel injection engine, delivering a maximum power of 77 kW and a maximum torque of 155 Nm.
When I drive the Lavida, I often operate the hood. The steps are quite simple: First, sit in the driver's seat, look down near your left foot, and you'll find a hood release lever. Pull it with your hand, and you'll hear a click—the hood will pop up slightly. Then, get out of the car and walk to the front. At the center of the hood's leading edge, there's a safety latch or small lever. Reach in and gently lift it upward or push it sideways, and the entire hood will open. Remember, the car must be turned off and parked on level ground during the entire process to avoid the risk of rolling. Once the hood is open, it's convenient to check the engine oil, coolant, or battery condition. It's recommended to wear gloves to prevent finger scratches before operating. If the weather is cold or damp, the latch may rust, but gently moving it a few times will release it without affecting daily use.
