How to Open the Car Front Hood (Engine Hood)?

2 Answers
VonJayce
07/24/25 5:07am
For almost all vehicles, the hood release switch is located on the left side panel of the center console. Some models have it positioned slightly lower, near the bottom left corner, closer to the left foot area. Identify the hood release switch symbol. For lever-type switches, simply pull firmly; for button-type switches, just press it. After operation, the car hood will slightly pop up, revealing a 3-5 cm gap. There is also a secondary safety latch underneath the center of the hood. To fully open the hood, you must reach in and pull this safety latch to lift the hood. Additional relevant information is as follows: 1. Propping up the hood: After opening the engine compartment hood, remove the hood support rod and insert one end into the support slot to hold up the hood. If the hood is equipped with hydraulic supports, manual propping is unnecessary. 2. Closing the hood: Closing the hood is much simpler. Hold the hood with your hand, then lower and stow the support rod (this step is skipped for hydraulic supports), and gently lower the hood. At this point, the safety latch is not yet engaged, so place both hands directly above the hood and apply slight downward pressure to securely close it.
Was this review help?
6
0
Share
CadenRose
08/11/25 12:48am
Opening a car hood is actually quite simple, but it might be a bit confusing the first time. I once taught my nephew how to do it: First, bend down and look for the hood release lever on the lower left side of the driver's seat—usually a small handle with a car icon. Give it a firm pull, and you'll hear a 'pop' as it releases. Don’t rush to lift the hood just yet. Walk to the front of the car, slide your hand into the gap in the middle of the hood, and feel for a metal latch. Press this safety lock to the left while using your other hand to lift the hood. Remember to secure the hydraulic strut properly, and in winter, avoid touching frozen metal parts with bare hands. Older models might require a manual prop rod, which needs to be inserted into the triangular hole in the hood for safety.
Was this review help?
8
4
Share
Expand All
More Forum Discussions

What are the models of manual transmission fluid?

Manual transmission fluids are classified into six categories based on performance: GL1, GL2, GL3, GL4, GL5, and GL6. Manual transmission fluid, commonly referred to as gear oil, is primarily used for lubrication. In terms of oil characteristics, manual transmission fluid has a higher viscosity compared to automatic transmission fluid, and its replacement interval is generally shorter. Most household vehicles require manual transmission fluid replacement every 40,000 to 60,000 kilometers. There are various models of ATF (Automatic Transmission Fluid), each with different friction coefficients. Some car manufacturers select specific oil models based on the technical specifications of the vehicle's transmission. Using such oils helps maintain the transmission's mechanical performance and prolong its lifespan.
15
3
Share

What to Do When the Charcoal Canister is Clogged?

The solution for a clogged charcoal canister: When you find that the charcoal canister is clogged, it is essential to clean or replace it promptly to avoid affecting vehicle performance. After driving the car for a while, stop the vehicle while keeping the engine running, then manually open the fuel filler cap. If you hear a suction sound, it indicates that the charcoal canister is clogged. Additionally, when the charcoal canister is blocked, the car may emit a noticeable gasoline odor. If the car has been parked outdoors for an extended period, opening the fuel tank cap may result in a large amount of gas escaping, which also signifies a clogged charcoal canister. When the charcoal canister is blocked, the pipe leading to the fuel tank gets obstructed, causing the fuel tank to bulge, which can easily interfere with the engine's normal operation.
14
3
Share

Does the BYD Qin automatically close windows when locked?

BYD Qin automatically closes windows when locked. Here is relevant information about automatic window closing: 1. Automatic window closing upon locking is achieved by the central control system of the power windows sending a signal to the windows after the car is locked; 2. Power windows use the vehicle's power supply to drive the window regulator motor: the regulator moves up and down, causing the window glass to move up and down, achieving the effect of automatic window opening and closing. Power windows allow the driver or passengers to operate the window switches while seated, making it convenient and enhancing driving safety; 3. The power window system consists of the window, window regulator, motor, relay, switch, ECU, and other components; 4. Windows generally use bidirectional permanent magnet or wound motors: each window is equipped with a motor whose current direction is controlled by a switch, enabling the window to move up and down. To prevent motor overload, one or more thermal circuit switches are installed in the circuit or motor to control the current. This prevents the motor from being powered for too long and burning out when the window glass reaches its limit position or cannot move freely due to icing.
9
1
Share

How to reset the maintenance reminder for a 2015 Focus?

The method to reset the maintenance reminder for a 2015 Focus is as follows: First, turn off the ignition. Press the button at the bottom right of the instrument panel, then turn on the ignition. At this point, you will notice that the maintenance indicator (a small wrench symbol) on the instrument panel stops flashing. Release the button and press the button at the bottom left. You will see that the small wrench symbol on the instrument panel has disappeared, indicating that the maintenance light has been successfully reset. The advantages of the maintenance reminder light include the following three points: 1. Improves vehicle performance: Regular maintenance can enhance the car's performance and extend its lifespan. 2. Saves fuel: Proper vehicle maintenance can help save fuel during driving. 3. Reduces emissions: After a full maintenance service, the car's carbon monoxide emissions during idle driving will be reduced.
7
5
Share

Does running a yellow light count as running a red light?

Running a yellow light and running a red light are both considered the same traffic violation—driving a motor vehicle in violation of traffic signal regulations. According to Article 2 of the "Scoring Standards for Road Traffic Violations," if a motor vehicle driver commits any of the following violations, they will be penalized with 6 points: driving a motor vehicle in violation of traffic signal regulations. The "Road Traffic Safety Law of the People's Republic of China" Article 26 stipulates: Traffic signals consist of red, green, and yellow lights. A red light indicates prohibition of passage, a green light indicates permission to proceed, and a yellow light serves as a warning. Article 38 of the "Road Traffic Safety Law" states: A yellow light serves as a warning, and motor vehicles should slow down when passing through an intersection. If a vehicle has already crossed the stop line when the yellow light is on, it may continue to pass; otherwise, it should stop. Article 38 of the "Implementation Regulations of the Road Traffic Safety Law of the People's Republic of China" specifies the following for motor vehicle and non-motor vehicle signals: When the green light is on, vehicles are permitted to proceed, but turning vehicles must not obstruct the passage of straight-moving vehicles or pedestrians. When the yellow light is on, vehicles that have already crossed the stop line may continue to proceed. When the red light is on, vehicles are prohibited from proceeding. At intersections without non-motor vehicle or pedestrian crossing signals, non-motor vehicles and pedestrians should follow the motor vehicle signal indications. When the red light is on, right-turning vehicles may proceed if they do not obstruct the passage of other vehicles or pedestrians. Electronic police capture red-light running violations based on the following three photos, which are reviewed by traffic police to determine whether a red light was run: An image of the vehicle not having passed the stop line when the red light is on. An image of the vehicle's front wheels pressing against the stop line. An image of the vehicle's entire body having crossed the stop line. If these three photos show that the vehicle moved beyond the stop line while the red light was on, the traffic police can confirm it as a red-light running violation during review. To avoid running a yellow light: Slow down when approaching an intersection, maintain a speed of 20–30 km/h, keep a safe distance from the vehicle ahead, and avoid tailgating or rushing through a yellow light. Alternatively, pay attention to the traffic signal in advance; observe the duration of the green light—if traffic is light and the green light lasts longer, prepare to slow down.
18
3
Share

What is the difference between Toyota C-HR Kuraku and Kuyue?

C-HR Kuraku and Kuyue have the same guide price and configurations, with only slight differences in appearance. Here is the relevant information: 1. The Kuraku has a body size of 4405*1795*1565mm, equipped with a 2.0-liter four-cylinder naturally aspirated engine. The entire series comes with a CVT continuously variable transmission (simulating 10 gears), delivering a maximum horsepower of 171 hp, a maximum power of 126 kW, a maximum torque of 203 N·m, and a top speed of 187 km/h. The combined fuel consumption by the Ministry of Industry and Information Technology is 5.7L/100km. 2. Both the C-HR Kuraku and Kuyue versions feature high safety configurations, including front and rear head airbags, ISOFIX child seat interface, ABS anti-lock braking system, brake force distribution system, brake assist system, traction control system, vehicle stability system, lane departure warning system, and active braking system.
8
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.