How to Open the Accord Hood?

2 Answers
GenevieveLee
07/30/25 1:21am
Steps to open the Accord hood: 1. Pull the lever located near the left foot in the driver's cabin upwards until you hear a click, which will partially open the hood. 2. Above the logo, there is a gap in the hood. Insert your left hand to find a small lever, lift it upwards while using your right hand to raise the hood. The Accord is a mid-size car launched by GAC Honda. In terms of body dimensions, the car measures 4893mm in length, 1862mm in width, and 1449mm in height, with a wheelbase of 2830mm. From the side view, the car features a three-dimensional waistline design that runs from the front to the rear, visually elongating the vehicle's body.
Was this review help?
16
5
Share
KathrynMarie
08/15/25 6:59am
I'm a seasoned Accord driver, and I always take extra care when opening the hood. First, sit in the car and locate the small lever under the left side of the driver's seat, near the foot pedal. Pull it firmly until you hear a click. Then, walk to the front of the car and look for a small rod under the center of the hood, usually marked with the Honda logo or a groove. Feel for it with your hand and gently push it downward to lift the hood. Always make sure the car is parked and turned off to avoid burns or accidents. New drivers might find the position a bit tricky, but the Accord's design is quite user-friendly—just practice a few times. I often open the hood to check the oil and coolant to keep the car running smoothly—this step is crucial for maintenance. If it gets stuck, don't force it; the latch might not be fully released. Gently wiggle the hood and try again. With gas prices so high these days, regular engine checks can save you a lot on repairs. Hope this helps!
Was this review help?
18
3
Share
Expand All
More Forum Discussions

Which gear should be used for a left turn in Subject 3?

Turning can be done in third gear, but the speed should be controlled at around 20 km/h. It can also be done in second gear, but idling is not allowed. After turning, you should immediately shift to third gear. Below is the relevant content: Deceleration and downshifting: During the C1 Subject 3 test, the requirement for turning gear is to decelerate and downshift. Otherwise, it is easy to have a mismatch between speed and gear, which may result in point deductions and can also cause the car to stall. It is recommended to decelerate and downshift. Subject 3: Also known as the road test, it generally includes: preparation before starting, starting, driving straight, gear shifting operations, changing lanes, pulling over, going straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school zones, passing bus stops, meeting oncoming vehicles, overtaking, making U-turns, and night driving.
4
1
Share

Can Old Motorcycles Be Licensed?

Old motorcycles can be licensed, but the prerequisite is that all procedures are complete and the vehicle's factory certificate is within the validity period. Taking Chengdu City as an example, the materials required for motorcycle licensing are as follows: Material 1: Original identity proof of the vehicle owner (for residents, the identity proof is the "Resident Identity Card" or "Temporary Resident Identity Card". For mainland residents living in temporary residences, the identity proof is the "Resident Identity Card" or "Temporary Resident Identity Card", along with the residence or temporary residence certificate issued by the public security authority); Material 2: Original proof of the vehicle's origin; Material 3: Original factory certificate of conformity for domestically produced motor vehicles; original "Goods Import Certificate" for imported motor vehicles; original "Notification of Entry (Exit) and License (Cancellation) for Vehicles under Customs Supervision of the People's Republic of China" for customs-supervised motor vehicles.
4
4
Share

What are the four basic types of car insurance?

Car four basic insurance are vehicle damage insurance, third-party liability insurance, no-deductible insurance, and passenger insurance. The following is the relevant introduction: Vehicle damage insurance: Vehicle damage insurance, abbreviated as 'vehicle loss insurance', is the most widely used type of vehicle insurance. Whether it's minor scratches or serious damage, the insurance company will cover the repair costs. Third-party liability insurance: Third-party liability insurance refers to the financial liability that the insured or their permitted drivers must bear for accidental injuries or direct property damage to third parties caused by the use of the insured vehicle during an accident, which the insurance company is responsible for compensating. No-deductible insurance: No-deductible insurance means that if an accident within the scope of insurance liability occurs to a vehicle insured with vehicle damage insurance and third-party liability insurance, resulting in vehicle damage (excluding theft) or third-party liability compensation, the insurer is responsible for compensating the amount stipulated in the 'Terms'. Passenger insurance: Passenger insurance refers to the financial liability that the insured must bear for personal injuries or deaths of passengers in the insured vehicle caused by an accident during the use of the insured vehicle by the insured or their permitted legal drivers during the insurance period, for which the insurer is responsible for compensating according to the provisions of this insurance contract.
16
0
Share

Can a Car Pass the Annual Inspection After Air Intake Modification?

Modifying a car's air intake system will prevent it from passing the annual inspection. However, modifications to the body color, engine, fuel type, and frame number are allowed, with the exception of three colors reserved for special vehicles, which cannot be used. Below is additional information: Permitted modifications: Changes to the body color, engine, fuel type, and frame number are allowed, but three colors are reserved for special vehicles and cannot be used; red is for firefighting vehicles, yellow for engineering rescue vehicles, and white over blue for national administrative law enforcement vehicles. Modifications to the body, frame, or engine are only permitted if the original parts are damaged beyond repair or have quality issues. Legal basis: Article 17 of the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China" states that if the registered contents on the vehicle's license do not match the actual condition of the vehicle during the safety technical inspection, or if the compulsory third-party liability insurance certificate is not provided as required, the inspection will not be passed.
11
3
Share

How to reset the maintenance light on Suzuki Ciaz?

Suzuki Ciaz maintenance light reset method is as follows: On the trip mileage display interface, press the right handle for more than 5 seconds until OIL appears in the lower right area of the display; quickly press the right handle 5 times within 2 seconds; OIL will blink 3 times and then turn off, indicating the reset is complete and the maintenance light is cleared. Additional information: 1. Car maintenance refers to the regular preventive work of inspecting, cleaning, supplying, lubricating, adjusting, or replacing certain parts of the vehicle, also known as vehicle servicing. 2. Modern car maintenance mainly includes the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, etc. The purpose of car maintenance is to keep the vehicle clean, maintain normal technical conditions, eliminate potential hazards, prevent faults, slow down deterioration, and extend the service life. 3. Routine maintenance includes changing engine oil and oil filter, replacing three filters (air, cabin air, and fuel filter), checking and topping up brake fluid, coolant, and power steering fluid (replacing if necessary). The first maintenance for a new car is at 5,000 km, which is free of charge. Remember to bring the maintenance manual, user manual, service network directory, first free maintenance voucher, and pre-delivery inspection certificate.
20
0
Share

What Happens If You Put Diesel in a Gasoline Car?

Putting diesel in a gasoline car can cause symptoms such as engine shaking, black smoke from the exhaust, or even failure to start the engine. Differences between diesel and gasoline: 1. Gasoline is highly volatile, while diesel is difficult to evaporate: Gasoline vehicles emit fuel evaporation pollutants. 2. Gasoline mixes easily with air and does not separate easily: Gasoline molecules are smaller, whereas diesel mixes unevenly with air, inevitably leading to localized oxygen deficiency or excess. When fuel burns at high temperatures with insufficient oxygen, it tends to carbonize and form soot. Diesel combustion also produces some odorous organic gases, which is why diesel engine emissions have a distinct smell. 3. Diesel has higher energy density: Diesel does not require a spark plug and ignites under high pressure, making it more efficient but also heavier and noisier. Gasoline requires ignition, so gasoline engines are smaller and quieter. 4. They smell different: Gasoline has a pungent odor, while diesel has a milder smell. 5. They differ in color: Gasoline is light-colored, while diesel is darker. Diesel is mainly used in trucks; diesel engines rely on compression ignition and operate at relatively low speeds, resulting in lower power compared to gasoline engines and slower vehicle speeds. Gasoline is primarily used in passenger cars; gasoline engines use spark ignition, and their compression ratios are generally lower, typically ranging from 8-11 for naturally aspirated engines and not exceeding 14 for turbocharged ones.
10
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.