How to Open a Sagitar Car Key?
4 Answers
First, release the mechanical key (press the button on the upper left corner of the key), then use a tool to tap the fixing pin to the black mark from the edge side. Be careful not to tap too deep as it may damage the internal circuit. Next, use pliers to pry open the key from the side to remove the key cover. Avoid excessive force to prevent internal components from falling out. Below is an introduction to car keys: 1. Mechanical car keys. Mechanical car keys are the most traditional and widely used type, featuring simple functions with only lock and unlock buttons. 2. Electronic car keys. Electronic car keys are a newer type with more functions. In addition to locking and unlocking, the display screen of an electronic key integrates vehicle information such as fuel consumption, remaining range, and door status. While electronic car keys offer more functions, they have a certain failure rate.
Opening the Sagitar key is actually quite simple, I've done it a few times myself. First, press the small button on the side of the key and pull out the metal mechanical key. At this point, you can see the gap in the middle of the key shell. Use a thin plastic piece to gently pry open along the gap, being careful not to use metal tools to avoid scratching the casing. After prying off the top cover, be cautious not to damage the circuit board, and watch out for small springs inside that might fall out. When reassembling, just align the clips and press gently—the whole process takes about five minutes. It's a good idea to take a photo before disassembling to avoid any reassembly issues. DIY battery replacement is very convenient and saves you hundreds compared to going to the 4S store.
Disassembling the Sagitar car key requires extra care, let me guide you through the process. Use a fingernail or bank card to insert into the key gap, then slide slowly along the edge until the clasp releases. When separating the upper and lower shells, be careful not to lose the internal rubber gasket - that's crucial for waterproofing. There's a small battery compartment on the circuit board; use tweezers to gently remove the old battery before installing the new one. Remember not to apply too much force throughout the process, as the plastic clasps can break easily. Before reassembling, check if the button rubber pads are properly aligned - once I forgot to align them which caused the lock button to get stuck. The whole process is actually quite interesting, and you can clean out accumulated dust inside the key as a bonus.
Disassembling the Sagitar key involves three steps. First, locate the shell clips, usually on the sides and bottom. Use a plastic pry tool to gently release the clips, avoiding screwdrivers to prevent scratches. Upon opening, immediately check the battery type—CR2032 is the most common. When replacing, ensure correct polarity to avoid reverse installation. Before closing the case, verify all buttons can press and reset normally. The key spring may pop out, so it's best to work on a cloth-covered surface. The entire process is simpler than imagined, even for beginners.
