How to Open a Chery Car Key?

[SanJoel]

There are two screws on the back cover of the car key. Use a screwdriver to remove each screw separately. After opening the back cover, you will see the battery board. Remove the old battery and install the new one. Reattach the back cover and tighten the screws to complete the process.

[LylaLee]

I've disassembled Chery car keys quite a few times before, and the method is fairly simple but requires careful attention. Typically, the key casing uses a plastic snap-fit design. Start by locating a small gap near the key handle or ring loop—that's the easiest spot to pry open. Use a small flathead screwdriver or even the edge of a credit card, gently insert it into the gap and slowly lift. Be careful not to apply too much force, or the casing may crack or internal components could get damaged. Once opened, you'll see a small battery, like a CR2025 coin cell, along with the circuit board and antenna. When replacing the battery, remember not to reverse the polarity—it's best to take a photo of the original position before removing it. When reassembling, align all parts first, ensure the snaps are properly seated, then press firmly around the edges until you hear a click. The whole process should be done gently in a clean environment to avoid dust affecting performance. For more complex smart keys with additional small components, take extra care—if it's your first time, don't rush it.

[LucilleAnn]

I've disassembled my own Chery car key a few times, usually when the buttons became unresponsive and needed battery replacement. The key's overall structure isn't overly complex. You just need to locate that tiny seam, typically along the edge of the key's front or bottom surface. I used the tip of small scissors to gently pry it open, revealing a straightforward interior with a small circuit board connected to the battery holder. If the battery is dead, simply remove it and replace it with a new one. Remember to keep your hands steady during the process to prevent small springs or chips from falling out. Before closing the case, ensure all components are properly positioned, then apply even pressure to snap the clips back in place, testing the button responsiveness afterward. It's wise to prepare a small tray for parts beforehand to prevent losing them. The whole process takes just minutes, though first-timers might find it slightly challenging - just be patient, or ask a friend for help if needed. Handling such minor repairs yourself saves on maintenance costs, which is quite economical.

[LaZachary]

As a frequent DIYer, taking apart car keys is super fun! The Chery key shell has plastic clips and can be opened with a gentle pry. Just insert a thin tool near the keyring and push. Inside, it's quite simple—just a small battery and a circuit board, making battery replacement super quick. When reassembling, align the parts and press firmly to lock. The whole process takes less than two minutes, offering low challenge but high satisfaction. It's perfect for beginners to practice—don't be afraid of mistakes, just enjoy the joy of problem-solving.

[JosephineLynn]

Disassembling a Chery car key requires special attention to safety risks. First, ensure the tools are appropriate—plastic pry tools are safe, while metal ones should be avoided to prevent short circuits or scratches on internal components. Before proceeding, check if the key has water damage or visible cracks; if so, send it for repair instead of forcing it open. When prying open the casing, apply gentle force starting from obvious gaps to avoid cracking the shell or dislodging parts. Avoid touching the circuit board with bare hands to prevent electrostatic damage—rubber gloves can be used for protection. When replacing the battery, ensure the correct model is used, and test the snap locks for firmness upon reassembly. Perform the entire process on a workbench to prevent losing small parts. If uncertain at any point, seek professional help immediately—don’t take risks. Safety always comes first, with prevention as the priority.