How to Match the Tire Pressure Monitoring System for the Great Wall H6?
2 Answers
The method to match the tire pressure monitoring system for the Great Wall H6 is as follows: 1. Connect the diagnostic tool to the CANbus diagnostic port; 2. Select the tire position of the sensor; 3. Place the setter near the tire valve of the sensor; 4. Press the button for the sensor's tire position, and the indicator light will flash; 5. When the indicator light stops flashing and the sensor's information is received, the matching is successful. Taking the 2021 manual urban edition Great Wall H6 as an example, its body dimensions are: length 4615mm, width 1860mm, height 1720mm, wheelbase 2680mm, fuel tank capacity 58L, and trunk capacity 347L.
I have a habit of personally performing tire pressure matching whenever there's a seasonal change or after tire rotation. The process is quite straightforward: First, park the car securely, turn off the engine but keep the key in the ON position. Then, look at the small screen on the dashboard and use the steering wheel buttons to enter the vehicle settings menu. Locate the "Tire Pressure Monitoring System" option and select the "Relearn" mode. The system will prompt you to process the four tires in sequence: I start with the left front tire, using a special tool to gently press the valve core and release a small amount of air until I hear a beep, then stop immediately. Next, proceed to the right front, right rear, and left rear tires in order, allowing the sensors to be redetected by the system. Once completed, save the settings and take a short drive to check if the warning disappears. The whole process takes about 10 minutes—don’t skip steps, as false alarms can make you nervous on the road. Remember to inflate the tires to the standard pressure values listed on the door sticker; otherwise, the matching won’t be accurate even if done correctly.
