How to manually reset the maintenance light for the 2018 MG6?
3 Answers
The specific steps to reset the maintenance light for the 2018 MG6 are as follows: 1. Turn on the ignition switch, hold down the "Reset Button 5" with one hand, and turn off the ignition switch with the other hand. 2. Keep holding the "Reset Button 5" until the clock and mileage on the dashboard completely disappear, then release the button. 3. Press and hold the "Reset Button 5" again with one hand, then turn on the ignition switch. At this point, the maintenance reminder on the dashboard will flash. Wait until the reminder stops flashing, then release the button. Below is some related information about the all-new MG6: The all-new MG6 is the first mass-produced vehicle based on the previous MGE-motion concept car, naturally incorporating many design elements from the concept car in its appearance. Officially dubbed the "Starlight Rider Shield Grille" and "London Eye Reflection" designs, these features further enhance the vehicle's appeal. The all-new MG6 features a dot-matrix design for the front grille, with the lower part shaped into a trapezoid. The side profile adopts a dual-waistline design, with the upper waistline extending from the rear of the headlight to the rear door panel, complementing the gently sloping roofline.
As a long-time MG6 owner, I'm quite familiar with resetting the maintenance light. After turning off the engine, press and hold the TRIP button on the right side of the dashboard for about 10 seconds. Then turn the key to the ON position without starting the engine. Keep holding the button, and you'll see the maintenance reminder light on the dashboard start flashing. Release the button only after the light completely goes off. Turn off the power and restart to check if the reminder is still there. If it persists, repeat the process. Doing it yourself saves time and avoids a trip to the dealership. Just remember to lower the steering wheel beforehand to avoid hand discomfort when pressing the button. This procedure doesn't harm the car - it simply resets the maintenance cycle record in the vehicle's computer.
Actually, resetting the maintenance light on the 2018 MG6 is quite simple: First, make sure the vehicle is completely turned off, then press and hold the reset button at the lower right corner of the instrument panel. Next, turn the key to the ignition-on position, and you'll see all the indicator lights on the instrument panel illuminate. Continue holding the button for about 15 seconds until the maintenance reminder symbol disappears. Then, turn off the power and restart the car, and you're done. I've seen many car owners at auto repair shops forget to start the operation with the car completely turned off, resulting in wasted effort. Also, a reminder: perform this operation right after the car's maintenance is done. Resetting without changing the engine oil might damage the engine.
