How to Make a Good Turn While Driving?

[KennedyFitz]

How to make a good turn while driving is as follows: 1. Always turn slowly: Especially when making a turn, you must slow down in advance. Only by going slowly can you pass safely or correct your mistake in time if you turn incorrectly. On the contrary, turning too fast can easily lead to danger. 2. When turning, always check the rearview mirror: Make sure there is no one behind or to the side of the car before turning. 3. Steering wheel control is crucial when turning: If you want to make a sharp turn, turn the steering wheel as much as possible, and then slowly straighten it out after completing the turn. For a wide turn, just turn the steering wheel slowly. 4. Watch out for blind spots when turning: Often, people look up but not down, or left but not right when turning, leading to overlooking blind spots, which can result in hitting the curb or causing a scrape. Always check for obstacles below the rearview mirror, and if necessary, open the car door to take a look before turning.

[Larry]

The key to a good turn lies in controlling speed and sightlines. When driving, I make it a habit to start slowing down at least 50 meters before entering the turn, reducing speed to a safe range—for example, maintaining 20-30 km/h under urban speed limits. Then, I check the rearview mirror and blind spots to ensure no vehicles are nearby, signaling early to alert other drivers. Avoid jerking the steering wheel mid-turn; instead, turn gently to maintain a smooth trajectory while focusing your gaze on the exit point of the turn. This naturally guides the car into a fluid motion. After exiting the turn, accelerate smoothly back into the lane, avoiding sudden acceleration or braking during the turn to prevent skidding. Exercise extra caution on rainy or slippery roads, as reduced tire grip requires earlier and more significant speed reduction for safe turning. Regular practice on various curves—such as highway ramps or sharp rural bends—will improve your skill over time. Remember, safety and smoothness are paramount—treat each turn as a small challenge.

[VanDaisy]

I've always believed that turning requires a balance of experience and courage. First, you need to slow down appropriately when entering a turn—don't go too fast, or the car might lose control and drift. I usually release the throttle about 50 meters in advance and lightly tap the brakes if needed to reduce speed, while signaling left or right to let others know I'm turning. During the turn, don't focus on the wheels; instead, look toward the direction you want to go—this naturally helps your body steer the wheel. Try to maintain a steady speed, avoiding sudden acceleration or hard braking, as this could cause the tires to lose grip and skid. After exiting the turn, gradually accelerate back into the lane and remember to turn off the signal. In crowded urban areas, always check blind spots before turning to watch for suddenly appearing pedestrians. Be extra cautious in rainy weather by reducing speed further. Practicing on mountain roads or winding routes a few times will improve your feel for it. Driving is all about developing habits—safety should always come first.

[Ray]

The key to smooth cornering lies in controlling speed and sightlines. Slowing down before entering a turn is crucial - I adjust speed according to the bend's sharpness, reducing to 15-20 km/h for hairpin turns while signaling to confirm safe positioning. During the turn, steer smoothly with eyes fixed on the target point to guide the vehicle, avoiding sudden wheel movements. Exit the bend by smoothly returning to lane center.