How to lift up the wiper of Nissan X-Trail?

1 Answers
EverettLee
07/29/25 4:12pm
To lift the wiper of Nissan X-Trail, follow these steps when the wiper is powered (you can turn the ignition switch to the ON position): Quickly and continuously push the wiper control lever upward. After the wiper completes its second wiping motion, it will stop in the middle position, allowing you to lift the wiper arm. Below is the method for replacing the wiper blade of Nissan X-Trail: 1. Lift the wiper arm from the windshield. Lift the driver's side first, then the passenger side. 2. Press and hold the release lug. Slide the wiper blade along the wiper arm to remove it. 3. Remove the old wiper blade and insert the new wiper blade into the wiper arm until you hear a click. 4. Gently lower the wiper arm back onto the windshield. Test the wiper by spraying water and ensure there is no abnormal noise during operation and the view is clear after wiping.
Was this review help?
6
4
Share
More Forum Discussions

What are the reasons for water ingress in the rear seat of the Regal?

Reasons for water ingress in the rear seat of the Regal: worn sealing strips, damaged trunk, etc. Here are the specific reasons: Worn sealing strips: Various parts of the vehicle body use sealing strips to ensure waterproofing. The sealing strips are made of rubber material, which has a certain degree of strength and hardness and does not deform under certain pressure conditions. However, long-term exposure to air can easily cause the sealing strips to age or wear out, ultimately leading to water ingress in the trunk. Damaged trunk: The design of the car's trunk follows certain rules, and typically, the body has corresponding drainage curvature designs in various areas. If the shape of the trunk is compromised, it can easily lead to severe water leakage when exposed to rain.
17
2
Share

What is the recommended tire pressure for CRV?

The standard tire pressure for Honda CRV is generally between 2.2-2.5 BAR. As long as it's within this range, it's considered safe tire pressure. Hazards of reducing tire pressure: Lowering tire pressure can lead to two consequences: first, increased tire wear which shortens tire lifespan; second, increased fuel consumption. During summer when temperatures are high, especially when driving on highways at speeds of 100-120 km/h, the tire surface temperature can reach 80 degrees Celsius or even exceed 100 degrees, causing internal pressure to rise. Hazards of increasing tire pressure: As for increasing tire pressure, the only benefit is reduced fuel consumption. However, besides the risk of tire blowout, increasing tire pressure brings many disadvantages such as longer braking distance, which is unfavorable for safe driving.
1
3
Share

What is the actual fuel consumption of the Land Rover Range Rover Evoque 2.0t?

The Land Rover Range Rover Evoque is equipped with a 2.0T turbocharged engine, paired with a 6-speed automatic transmission. The official combined fuel consumption certified by the Ministry of Industry and Information Technology is 7.2L/100Km. However, the actual fuel consumption of the Range Rover Evoque is certainly higher. Actual fuel consumption of the Land Rover Range Rover Evoque: The lower fuel consumption is around 10L/100Km, while the higher fuel consumption can exceed 13.0L/100Km. Based on these figures, the average fuel consumption of the Range Rover Evoque is calculated to be 11.75L/100Km. Factors affecting fuel consumption: The curb weight of this vehicle exceeds 1.8 tons, which can influence fuel consumption to some extent.
2
5
Share

Where is the memory card slot located in a car dash cam?

Car dash cam memory card slots are typically located near the cigarette lighter. Here is relevant information about car dash cam applications: Accident reconstruction: During traffic incidents such as vehicle collisions, rear-end accidents caused by illegal overtaking, or pedestrian injuries, the dash cam provides evidentiary recording materials. The footage can be replayed through in-car DVD systems or mobile devices. Security monitoring: The dash cam continuously monitors vehicle conditions. When integrated with remote network control, it can capture interior and exterior footage upon command in case of vehicle theft, providing valuable clues for recovery.
11
2
Share

How to Check if a License Plate is Archived?

You can check whether a license plate is archived through the vehicle management office's file inquiry system. Below is relevant information about license plate archiving: License plate archiving time: Under normal procedures, license plates are usually archived within three working days after vehicle transfer is completed. However, if the original owner needs to re-select the original license plate number, waiting for the archiving time alone is not sufficient, as the vehicle management backend also needs to upload the original license plate information to the system. Generally speaking, it's better to wait about 7 to 15 days after vehicle transfer before applying to use the original license plate number. Methods to check license plate archiving: With advanced internet technology today, license plate archiving status can be checked through the vehicle management office's file inquiry system or via some automotive-related mini-programs.
5
3
Share

Should I buy the Haval H6 with 1.5T or 2.0T?

Haval H6 1.5T and 2.0T differences are as follows: Configuration and Performance: The 1.5-liter turbocharged engine of the Haval H6 has a maximum power of 110kW, a maximum torque of 210Nm, a maximum power speed of 5600rpm, and a maximum torque speed range of 1800 to 4400rpm; the 2.0-liter turbocharged engine has a maximum power of 145kW, a maximum torque of 345Nm, a maximum power speed of 5500rpm, and a maximum torque speed range of 2000 to 3200rpm. Technology Features: The 1.5T is equipped with VVT technology and uses an aluminum alloy cylinder head and block; the 2.0T is equipped with DVVT technology and uses an aluminum alloy cylinder head and a cast iron block.
11
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.