How to Lift Up the Rear Seats of Haval M4?

1 Answers
LeEthan
07/30/25 12:42am
Here is the method to lift up the rear seats of Haval M4: On both sides of the rear seats, there is a switch near the headrest. Press the switch and push it forward to fold the seatback. Open the rear trunk, and underneath the seats (if not visible, it might be pressed under the seat), there is a black strap. Pull the strap backward and lift the seat upward. For more details about the Haval M4: 1. In terms of exterior dimensions, the Haval M4 can be considered a typical compact SUV. Looking at the domestic SUV market, it seems only the Haval M series has ventured into this niche SUV segment. With a ground clearance of 185mm and relatively large tire size, its off-road capability is evident. For consumers who desire an SUV but are concerned about urban parking difficulties, the Haval M4, as a compact SUV, might be an ideal compromise. 2. In terms of power performance, the Haval M4 is equipped with a self-developed engine by Great Wall—a 1.5L VVT all-aluminum engine. This engine is widely used in multiple products under the Great Wall brand, and its mature reliability is beyond doubt. With 78kW and 139N·m, it should be more than sufficient to drive this small vehicle. Four-wheel disc brakes are uncommon in this class, and although the rear longitudinal arm torsion beam composite suspension is a semi-independent suspension, it aligns well with the Haval M4's positioning.
Was this review help?
20
3
Share
More Forum Discussions

What Causes the Loud Engine Noise in Teana 2.5 During Startup?

The loud engine noise in a Teana 2.5 during startup can be attributed to the following reasons: Inadaptability to New Oil Viscosity: After prolonged use, the engine oil becomes thinner and carbon deposits accumulate. When new oil is replaced, the engine may not adapt to the oil's viscosity immediately, potentially causing higher RPMs and resulting in louder engine noise. It is recommended to switch to high-quality engine oil. Insufficient Coolant: In low-temperature conditions, insufficient coolant levels can lead to increased engine noise. It is essential to regularly check the coolant level and top it up as needed. Abnormal Shock Absorbers: Issues with the vehicle's shock absorbers can also cause the engine noise to become louder. Drivers should pay attention to the condition of the shock absorbers during regular use to avoid potential malfunctions. If problems are detected, it is advisable to visit a repair shop for maintenance.
9
2
Share

What are the reasons for the Mercedes-Benz C260L display screen not lighting up?

There are several reasons why the Mercedes-Benz C260L display screen may not light up: Defects in the central control system: Due to incompatibility between some brands and models of mobile phone Bluetooth, third-party software, and the main unit software, the central control screen may go black when connecting or playing songs. In this case, the central control system usually returns to normal after a restart. Issues with the USB port in the central armrest: If something is plugged into the USB port in the central armrest, it may cause the screen to go black. The solution is simple: just unplug the USB device. Power line failure: If the issue is caused by a power line failure, it can only be repaired at a 4S shop, as line faults cannot be handled on your own.
15
4
Share

What are the dimensions of the WM Motor trunk?

The WM Motor EX5 trunk dimensions are: height 760mm, depth 850 to 1760mm, width 1070mm, with a regular capacity of 488 liters. If the rear seats are folded down, the trunk volume of the WM Motor EX5 can be increased to 1500 liters. However, the floor is not completely flat after folding down the rear seats, which is a bit of a downside. Trunk cleaning method: If the plush part of the trunk gets dirty, the correct way to clean it is to use multi-function foam or a brush to remove the dirt. Also, pay attention to the edges and grooves of the trunk. Additionally, during the cleaning process, make sure to clean the dirt from the trunk edges and grooves. After cleaning, perform odor treatment again. Trunk maintenance tips: Purchase a trunk mat to prevent dirt or liquids from entering the trunk and damaging its surface, while also preventing items inside the trunk from sliding and reducing the likelihood of contamination or damage.
19
3
Share

Is SWM a Joint Venture Car?

SWM is not a joint venture car; it is a domestic independent brand. SWM was originally an Italian bankrupt motorcycle brand, first established in 1971, representing the craftsmanship spirit of Italian manufacturing. It was later fully acquired by Chongqing XinYuan in China and is now an SUV brand. Below is an introduction to the current three major series and thirty-one models of SWM: SWM X7 (including 1.8L manual transmission/4 models, 1.5T manual transmission/4 models, 1.5T automatic transmission/4 models); SWM X3 (including 1.6L MT/4 models, 1.5T MT/4 models, 1.5L MT/2 models, 1.5L/1 model); SWM G01 (including 1.5T-6MT manual transmission, Enjoy, Type, Smart, Proud UP/4 models, 1.5T-6AT automatic transmission, Type, Smart, Proud, Noble UP/4 models).
11
5
Share

Why does an Audi shake and stall during cold starts?

Audi vehicles shaking and stalling during cold starts are primarily caused by excessive carbon buildup. Excessive carbon deposits can lead to insufficient air intake, making it difficult to start the engine or causing it to shake and stall. Carbon buildup typically occurs in several areas, including the inner walls of the throttle body, the intake valve heads, the inner walls of the intake manifold, the piston tops, and the inner walls of the combustion chamber. Below are detailed explanations: 1. Excessive carbon deposits on the inner walls of the throttle body can result in insufficient air intake, making it difficult to start the engine or causing it to stall easily at idle. Once the coolant temperature reaches the engine's normal operating temperature, the throttle opening may exceed the normal idle value, causing the ECU to repeatedly adjust the throttle valve position. This results in fluctuating idle speeds and shaking or stalling during startup. 2. Heavy carbon buildup on the intake valve heads can cause most of the fuel injected by the fuel injector during a cold start to be absorbed by the carbon deposits. This leads to insufficient fuel entering the combustion chamber, resulting in a lean mixture that is difficult to ignite. Only after multiple injections during cranking does enough fuel enter the combustion chamber for ignition. In such cases, the engine is prone to shaking and stalling during startup.
9
1
Share

What is the reason for the air release sound after the turbo kicks in on the Haval H6?

Haval H6 turbo kicks in after the air release sound is the sound of the pressure relief valve working, which is a normal phenomenon. Turbo working principle: When the turbo starts working while accelerating, it compresses a large amount of air and pushes it through the throttle into the engine combustion chamber. When the driver releases the accelerator pedal, the throttle closes. However, the turbo blades do not stop working immediately. At this time, there is still residual compressed air in the intake pipe between the turbo and the throttle. If this air is not released in time, the strong pressure can cause damage to the throttle and turbo blades. Function of the pressure relief valve: The valve of the pressure relief valve will release the residual compressed air in the pipe in time when it detects that the air pressure in the intake pipe is too high, thereby protecting the throttle and turbo blades. It also reduces the occurrence of turbo lag, making the engine work more smoothly. The air release sound heard is the "noise" generated when the pressure relief valve discharges the compressed air.
10
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.