How to Know the Size of Wiper Blades?

1 Answers
LaCaroline
07/30/25 12:08am
Measure the length of the wiper blade rubber strip with a ruler to determine the wiper blade size. Below are the specific details about wiper blades: 1. Common sizes of car wiper blades correspond to the length of the rubber strip. 14 inches is 350mm, 15 inches is 375mm, 16 inches is 400mm, 17 inches is 425mm, 18 inches is 450mm, 19 inches is 475mm, 20 inches is 500mm, 21 inches is 525mm, 22 inches is 550mm, 24 inches is 600mm, and 26 inches is 650mm. 2. Wiper blades are rubber products and it is best to replace them once a year. If the water-sweeping ability of the wiper blades declines, it will be very difficult to observe the road conditions while driving in the rain. Before daily use, clean the front windshield to prevent sand particles on the glass from damaging the wiper blades and reducing their lifespan.
Was this review help?
1
3
Share
More Forum Discussions

What causes the warning light to flash?

The flashing engine warning light in a car is primarily caused by the oxygen sensor detecting an abnormal air-to-fuel ratio. Here are the reasons why the engine warning light may illuminate: 1. Damaged, poorly connected, or interrupted sensor signals; 2. Poor engine maintenance; 3. Low-quality fuel or engine oil; 4. Incomplete combustion of the air-fuel mixture; 5. Faulty spark plugs or ignition coils; 6. Fuel pump failure or clogged fuel lines; 7. Clogged air conditioning filter. Additional information: An engine is a machine that converts other forms of energy into mechanical energy, including internal combustion engines (reciprocating piston engines), external combustion engines (Stirling engines, steam engines, etc.), jet engines, electric motors, etc. The term 'engine' can refer to either the power generation device or the entire machine including the power unit.
7
2
Share

Which Porsche model is wp1ag292?

Porsche wp1ag292 refers to the Cayenne. Cayenne dimensions: The Cayenne is a mid-to-large size 5-door, 5-seater SUV with the following body dimensions: length 4918mm, width 1983mm, height 1696mm, wheelbase 2895mm, fuel tank capacity 90 liters, drivetrain front-engine four-wheel drive, and both front and rear suspensions use multi-link independent suspension. Cayenne configuration: The Porsche Cayenne is equipped with a 2.9T twin-turbocharged engine and an 8-speed automatic transmission, with a maximum power of 324 kilowatts, maximum power speed between 5700 to 6600 revolutions per minute, maximum torque of 550 Newton meters, and maximum torque speed between 2000 to 5500 revolutions per minute.
12
1
Share

How much coolant should be added to a Mercedes GLK?

Mercedes GLK requires approximately 6 liters of coolant. Method for adding coolant: Park the car on a level and solid ground, wait for the engine to fully cool down, open the engine hood, and locate the purple oval-shaped coolant reservoir on the left side. When the engine is cold, check the coolant level via the markings on the side of the expansion tank. When refilling coolant, use a suitable cloth to cover the expansion tank cap to prevent burns from hot coolant or steam on your hands and arms. Precautions for using coolant: Do not open the coolant reservoir cap or drain valve immediately after driving, as the temperature of the coolant or water is very high at this time to avoid burns. The effective service life of coolant is generally two years. Replace it when expired or if the coolant appears dirty. During replacement, ensure all old coolant is completely removed and the reservoir is thoroughly cleaned.
1
0
Share

What are the reasons for high fuel consumption in motorcycles?

The reasons for high fuel consumption in motorcycles are as follows: 1. Fuel intake issues: A clogged air filter causes poor air intake, forcing the cylinder to suck in more gasoline. Improper adjustment or maintenance of the carburetor, an overly rich fuel mixture, excessively high main jet needle position, or high fuel level can all lead to increased fuel consumption. 2. Component wear problems: Slippage caused by worn clutch plates or aging springs. Overly tight brakes, cylinder and valve wear leading to reduced cylinder pressure, decreased oil output, and poor lubrication of various parts can result in excessive wear and increased fuel consumption. 3. External driving issues: Insufficient tire pressure. Frequent low-speed driving and poor road conditions causing repeated acceleration and deceleration, as well as frequent braking.
8
1
Share

How to Interpret Traffic Signals for Left Turns?

Here are the methods for interpreting traffic signals: When the green left arrow illuminates, left turns are permitted. If there is no dedicated left arrow signal and only a circular green light is present, left turns may proceed when the green light is active. Typically, the left turn phase follows the red light countdown, with straight-through traffic allowed only after the left turn countdown completes. Some intersections prohibit left turns entirely, so clear observation is essential. Relevant information: Road traffic signal lights constitute a category of traffic safety products. They serve as vital tools to enhance road traffic management, reduce traffic accidents, improve road utilization efficiency, and optimize traffic conditions. These signals are deployed at intersections such as crossroads and T-junctions, controlled by traffic signal controllers to ensure safe and orderly passage for both vehicles and pedestrians.
7
3
Share

What to Do When the Nissan Teana Smart Key Battery Dies?

The Nissan Teana smart key contains a hidden mechanical key that can be used to open the door. Below are the main functions of the smart key: 1. When approaching the car, the key and the vehicle begin exchanging preset command information via radio waves. Subsequently, the car's locking system and engine control system are fully activated. 2. When opening the door, as soon as the driver touches the door handle, the sensor detects this pressure, and the servo motor unlocks the door. The seat and side mirrors then automatically adjust to the driver's preferred position. 3. Before starting, when the driver presses the brake pedal, the steering wheel lock is released, and the start button is also activated. 4. When exiting the vehicle, the driver must press the lock button. If the turn signals flash, it indicates that the doors are securely locked.
11
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.