How to Install the Applied ETC?
1 Answers
ETC installation method is as follows: Upon receiving the device, first check if the ETC card and electronic tag (OBU) are damaged. Press the anti-tamper button on the back of the OBU, the red light will briefly illuminate, and the OLED screen will display "Label Invalid" and "Please Insert Card," indicating the device is functioning normally. Clean the front windshield, ensuring the glass surface is smooth, clean, and dry. Then peel off the protective film on the back of the OBU adhesive and stick it to the installation position. Press firmly for 2-3 minutes to remove air bubbles. Insert the ETC card with the front facing the driver and the back facing the front glass, ensuring the chip is inserted into the OBU device. Where can ETC be installed: For small vehicles such as cars and minivans, the OBU device should be installed on the upper middle part of the front windshield. For large vehicles like trucks and buses, the installation position is on the lower middle part. ETC installation position requirements: The height should not be less than 1.2 meters or more than 2.5 meters; the installation angle N should be between 30º and 90º (the angle between the electronic tag surface and the horizontal plane).