How to Install License Plate Screws?
2 Answers
First, drill pilot holes with self-tapping screws, then tighten the screws. Important Notes: The front license plate should be installed in the middle or slightly to the right of the vehicle's front end, while the rear license plate should be installed in the middle or slightly to the left of the vehicle's rear end. Installation should not affect safe driving or license plate recognition. The plate must be installed without any deformation or obstruction, horizontally level, and vertically perpendicular to the ground with a tilt angle not exceeding 15 degrees. License Plate: Commonly known as a vehicle plate or license plate, it refers to the vehicle's registration number. It displays the vehicle's registration number, registration region, and other relevant information. Its primary function is to identify the vehicle's registered region and allow lookup of the vehicle's owner and registration details through the plate number.
I just got my new license plate last month, and installing the screws was pretty straightforward. First, align the holes on the license plate with the corresponding positions on the car, place the plate properly, then use the provided screwdriver or wrench to screw them in. Be careful not to overtighten to avoid damaging the screws or scratching the paint—just apply moderate force. After installation, gently shake the plate to check for looseness and ensure it’s secure. If unsure, adding a washer can improve stability. The whole process usually takes less than five minutes—just take your time to avoid stripping the screws, which would be a hassle to redo. Every time I wash my car, I also check if the screws are still tight, because road safety comes first.
