How to Install Daytime Running Lights on Lavida?

[Devon]

Lavida installation steps for LED daytime running lights are as follows: First, use a flat-head screwdriver to remove the original fog light cover. Then, snap the daytime running lights into the slot of the original fog light cover position. Next, open the car's front hood and install the controller in a low-temperature area. The controller has four wires at the back: connect the red wire to ACC, the black wire to the battery negative terminal, the yellow wire to the positive terminal, and the white wire to the headlights. Start the car, and if the daytime running lights illuminate automatically, the installation is successful. Below are the precautions for using daytime running lights: 1. Daytime running lights should not be used as illumination or functional driving lights in poor driving conditions such as dawn, dusty weather, or dark areas. 2. When connecting the red and black wires to the battery, the engine must be turned off for at least three minutes. 3. During installation and wiring, avoid placing the power wires near heat sources, and position the controller in a ventilated area. 4. Use the matching controller wiring harness.