How to Install an ETC Device?

[Wyatt]

ETC device installation process is as follows: Upon receiving the device, first check whether the ETC card and the electronic tag (OBU) are damaged. Press the anti-tamper button on the back of the OBU, and the red light will briefly illuminate. The OLED screen will display "Tag Invalid" or "Please Insert Card," indicating the device is functioning properly. Clean the front windshield, ensuring the glass surface is smooth, clean, and dry. Then peel off the adhesive backing of the OBU and stick it to the installation position. Press firmly for 2-3 minutes to remove any air bubbles. Insert the ETC card with the front side facing the driver and the back side facing the windshield, ensuring the chip is properly inserted into the OBU device. ETC installation positions: For small vehicles such as cars and minivans, the ETC card and OBU device should be installed in the upper middle section of the front windshield. For large vehicles like trucks and buses, the installation position is in the lower middle section. ETC installation requirements: height should be no less than 1.2 meters and no higher than 2.5 meters; the installation angle N should be between 30º and 90º (the angle between the surface of the electronic tag and the horizontal plane).