How to Install a Vehicle License Plate?
2 Answers
Steps for installing a vehicle license plate: 1. Screw the bolt into the screw hole at the license plate installation position; 2. After checking the screw holes, pre-assemble each set of screws in order from top to bottom: bolt, anti-theft cap, and washer; 3. Screw the prepared screws into the screw holes—this step requires a screwdriver. Note that these screws can only be tightened and not loosened, so ensure success on the first attempt; 4. After tightening, gently press the anti-theft cap into place and make sure it is securely fastened. A vehicle license plate is a legal mark registered by the statutory authority, permitting the vehicle to drive on roads within the territory of the People's Republic of China. The license plate is usually mounted at a specific position on the vehicle, and its number serves as the vehicle registration code.
When installing license plates myself, the key steps are finding a flat parking spot, preparing a screwdriver, wrench, and the screw kit that comes with the plates. Proper positioning is crucial—the front plate goes right in the center of the bumper, while the rear one is placed below the trunk lid. Align the holes and slowly tighten the screws, being careful not to apply too much force to avoid damaging the paint. Make sure the screws are tight enough to prevent loosening at high speeds. Check that the plate is straight and the numbers aren’t obscured, as getting pulled over by the police would be a hassle. I also like to apply some rust inhibitor on the screws since exposure to weather can cause rust. After installation, give the plate a shake to test its sturdiness—the whole process takes about 15 minutes, but being thorough saves trouble later. It’s good to check the screws every couple of months to ensure they haven’t loosened, keeping your drives safer.
