How to Install a Rearview Camera?
2 Answers
First, install the rearview mirror part of the dash cam, including the mounting of the rearview mirror and the wiring for power supply. Near the license plate light on the rear trunk door, install the camera (the camera is usually secured with self-tapping screws). Remove the inner cover of the rear trunk door, and thread the camera wiring harness through to the passenger compartment, finally connecting it to the dash cam main unit.
I'm a big fan of tinkering with car equipment, and installing a backup camera is actually quite fun. Choosing a good kit is the starting point—both the camera and display need to be reliable in quality, which you can buy online, with prices ranging from a few hundred to over a thousand. During installation, first secure the camera near the rear license plate light, carefully drill holes without damaging the paint, and then fasten it firmly with screws. I prefer mounting the display on the windshield or dashboard, making sure it doesn’t obstruct the view. Wiring is the most tedious part—run the cables from the rear along the inner side of the car body, pry open the interior panels to tuck them in, and ensure the wires aren’t tangled. Finally, connect the power to the reverse light, use a multimeter to check the polarity to avoid short circuits. Test it by reversing to see if the image is clear and wide-angle without delay. DIY installation saves money and improves parking safety, especially when backing into a garage at night without worry. Remember to regularly clean dust off the camera to maintain a clear view.
