How to Install a Dash Cam?
3 Answers
Dash cam installation steps: 1. Remove the rearview mirror housing; 2. Take off the rearview mirror by pressing the two metal clips and sliding it downward; 3. After opening the rearview mirror cable housing, disconnect the connector for the anti-glare rearview mirror; 4. Open the dash cam base, align the left and right metal clips on the dash cam base with the sliding grooves on the rain sensor base, and push upward evenly on both sides until it slides to the bottom; 5. Connect the dash cam to the power source, then simply turn on the dash cam to use it. A dash cam is an instrument that records images, sounds, and related information during vehicle travel. After installation, it can record the entire driving process in video and audio, providing evidence in case of traffic accidents.
Installing a dash cam is actually quite simple. I've done it several times myself, so here are some tips. Finding the right position is crucial—I usually place it behind the rearview mirror on the windshield so it doesn't obstruct the view. Clean the installation area, attach the mount, and then clip on the dash cam. Wiring is key—I prefer routing the cable along the headliner and tucking it into the door seal, hiding it all the way to the cigarette lighter or fuse box for power. Last time, I installed a dual-lens model and spent some time adjusting the angles to ensure both front and rear views were covered. Remember to start the car and test the power supply to avoid it cutting out mid-drive. After installation, check the lens clarity and recording function—they might come in handy in case of an incident. The whole process takes about half an hour, and a little effort can save a lot of trouble.
I just finished installing my own dash cam using a kit I bought online. The steps were: first, stick the mount onto the windshield, positioning it slightly to the right of center to avoid obstructing the driver's view; then plug in the dash cam and start routing the wires. Initially, I didn't hide the wires properly, leaving them exposed and looking quite messy. Later, I got smarter and used a plastic pry tool to tuck the wires into the headliner gap, then ran them down along the weather stripping to the power source near the glove box. For power, you can choose between the cigarette lighter or the fuse box, with the cigarette lighter being the quicker option. After installation, be sure to power it on and test the recording quality. It took me several tries to adjust it to the perfect angle. Don't forget to clean the lens regularly. For beginners, I recommend starting with a simple single-lens model, as more complex ones can be prone to errors. The whole process isn't overly complicated, but it does require some patience—safety first!
