How to Insert an ETC Card?
4 Answers
ETC card insertion method: Insert the ETC card with the front side facing the driver and the back side facing the windshield, ensuring the chip area is inserted into the OBU device. Below are precautions for using ETC: 1. Installation position: The ETC device should be installed at a height no lower than 1.2 meters and no higher than 2.5 meters. The installation angle N should be between 30º and 90º (the angle between the electronic tag surface and the horizontal plane). For small vehicles like cars and minivans, the OBU device should be installed in the upper middle part of the front windshield. For large vehicles like trucks and buses, it should be installed in the lower middle part. 2. Transaction position: The ETC transaction sensing area is 8 meters, and the recognition speed in ETC lanes should be below 20km/h.
When I first installed the ETC in my car, I was a bit confused about inserting the card, but I figured it out later. Locate the small slot at the front of the device, with the metal chip side of the card facing upwards, and gently push it in until you hear a click indicating it's locked. Don't force it; if the direction is wrong, try another angle. Once inserted, the device will confirm with LED flashes or sounds. Keep the card clean and avoid leaving it in the car for too long to prevent dust buildup. ETC is truly a lifesaver on highways, allowing you to skip toll booth queues, save time and effort, and avoid traffic anxiety. I recommend practicing inserting and removing the card a few times on the installation day to get familiar with the feel, and checking if it's securely locked before heading out to avoid any hiccups at the toll gate. Clean the device slot during seasonal changes to prevent poor contact.
I frequently use ETC for commuting, so I'm very familiar with inserting the card. Hold the card steady, locate the slot on the device (usually on the top or side), align the chip end forward or upward, and gently insert it. Don't push too hard to avoid damaging the card tongue or internal springs. A green light and beep indicate successful insertion. Regularly remove and wipe the card to prevent dust from affecting recognition. Using ETC on highways eliminates the need to stop for toll payments, ensuring smoother passage and saving fuel costs. Remember not to shake the device after inserting the card to prevent it from popping out and interrupting the transaction mid-journey. Before traveling, I always check the card's status to ensure smooth highway access.
Installing ETC makes card insertion super easy. Hold the card correctly with the chip side generally facing up or towards the device logo, push it into the slot to feel the spring's rebound force, and a click sound means it's done. If inserted incorrectly, the indicator light will flash; adjust and try again. Once inserted, avoid frequent removal to reduce wear. ETC enables seamless highway access, improving driving efficiency and reducing noise pollution. Just perform regular checks to keep the slot clean.
