How to Identify New Cars and Stock Cars?

1 Answers
Aurora
07/29/25 11:12pm
Methods to identify new cars and stock cars are as follows: 1. Check the vehicle identification plate: The vehicle identification plate is usually located below the B-pillar on the passenger side and is easy to find. The vehicle identification plate is a label that indicates the basic characteristics of the vehicle, including the manufacturer, model, engine power, total weight, load capacity or passenger capacity, production number, production date, and manufacturer name. First, look at the manufacturing date. If the manufacturing date is within three months of the purchase date, it is not a stock car. If it exceeds three months, it can generally be considered a stock car. 2. Check tire wear and production date: Generally, new car tires show little to no wear. The tread hairs on the tire sidewalls should be clearly visible. If no tread hairs are found, caution is needed. Next, check the tire's production date. There is a series of numbers on the tire sidewall, such as 0717. The latter two digits (17) represent the production year, and the first two digits (07) represent the week, meaning the tire was produced in the seventh week of 2017. This allows you to calculate the tire's production date, which would be mid-February 2017. Then, compare it with the vehicle's production date on the identification plate. If the dates are close, it indicates the car is not a stock car. If there is a significant gap, be cautious. 3. Check the inside of the exhaust pipe: Insert a finger into the exhaust pipe. If the finger comes out clean, it is a new car. If it is dirty, be cautious. A new car's exhaust pipe should not be dirty. Additionally, the mileage on the odometer should not be the primary reference. 4. Inspect the engine compartment: Open the hood and check the engine compartment. If there is a thick layer of dust or oil stains, it suggests the car has been parked for too long or has been driven extensively. Also, carefully inspect the components in the compartment for deformation, discoloration, neatness, or signs of removal. 5. Check for aging or detached rubber parts: Open the doors and trunk lid, and carefully inspect the rubber seals. If the door seals are detached or show signs of aging, it indicates the car has been parked for a long time. Pull the seal at the door seam; if there are no signs of replacement, it is likely a new car. 6. Check the foot pedals: Open the door and inspect the foot pedals thoroughly, including the gaps. If the pedals show wear or excessive dust in the gaps, it might be a test-drive car or a stock car. If the pedals are clean, it is likely a new car.
Was this review help?
16
2
Share
More Forum Discussions

What is the coverage of vehicle glass insurance claims?

Glass insurance claim coverage is as follows: 1. Insurance liability: The insurance company is responsible for compensating for the separate breakage of the vehicle's windshield and window glass. The insurance company usually compensates for glass breakage based on actual losses. When applying for insurance, it is not necessary to determine the insured amount, but it is necessary to specify whether to insure with domestic or imported glass to determine the type of glass compensation during the claim. 2. Insurance compensation: The insurance company is responsible for compensating for the separate breakage of the vehicle's windshield and window glass. 3. Common exclusions: The insurance does not cover compensation for separate breakage of glass in the glass breakage insurance. The glass referred to in the glass breakage insurance includes the windshield and window glass, but excludes the headlight and mirror glass. If the headlight or mirror glass is broken or if breakage occurs during vehicle maintenance, the insurance company will not be liable for compensation.
9
1
Share

Can 12123 Handle Not Wearing a Seat Belt?

Drivers who violate the seat belt regulation can pay fines online through the traffic management platform 12123. The following is an introduction to Article 90 of the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China": 1. Introduction 1: If a motor vehicle driver violates the road traffic safety laws and regulations regarding road traffic regulations, they shall be given a warning or fined. If there are other provisions in this law, the punishment shall be imposed in accordance with those provisions. 2. Introduction 2: Drivers not wearing seat belts will be deducted 2 points, while passengers not wearing seat belts will not be deducted points but will be fined. 3. Introduction 3: Article 51 of the "Road Traffic Safety Law of the People's Republic of China" states that when a motor vehicle is in motion, the driver and passengers should use seat belts as required.
6
0
Share

What to Do If the Car Chassis Is Scraped and Leaking Water?

If the car chassis is scraped and leaking water, this situation should be taken seriously. You should immediately go to a repair shop for inspection to analyze the damaged parts causing the oil leak, such as the engine oil filter, oil pan gasket, damaged sealing ring, or front and rear crankshaft oil seals. The specific solutions for a scraped car chassis leaking water are as follows: 1. Situation 1: It may be that the chassis is scraped, causing the windshield washer pipe to leak. In this case, you need to go to a repair shop to replace the pipe. 2. Situation 2: It may not be a water leak but normal condensation from the air conditioning. Most cars do not have a water drainage hose at the bottom, so the condensation from the air conditioning is directly discharged from the chassis. 3. Situation 3: If the leaking liquid is colored, it indicates a leak in the cooling system, which requires immediate repair.
19
3
Share

Which Lynk & Co 02 model is equipped with a four-cylinder engine?

Lynk & Co 02's 2.0T model is equipped with a four-cylinder engine. Below is a detailed introduction about the Lynk & Co 02: 1. Overview: As the second model of the Lynk & Co brand, the Lynk & Co 02 is positioned as a high-energy coupe SUV, built on the CMA basic modular architecture. The dimensions of the Lynk & Co 02 are 4448/1890/1528mm in length/width/height, with a wheelbase of 2702mm. The ground clearance is 201mm. 2. Configuration: The overall layout and design of the Lynk & Co 02 continue the design of the Lynk & Co 01, and it is equipped with up to 17 intelligent driving technologies and advanced connected entertainment systems. The center console features a 10.25-inch touchscreen, equipped with functions such as reverse camera and GPS navigation. The new car is also equipped with configurations like automatic parking and AQS air quality management system.
12
3
Share

How to Remove Old Window Film Adhesive?

Here are the methods to remove old window film adhesive: 1. Apply vinegar: Use a cotton swab to evenly spread vinegar on the adhesive, then scrape and wipe it off with paper for a clean finish. 2. Apply essential balm: Initially, there may be no visible change when applying essential balm to the adhesive. Persistently scrape with a cotton swab, and the reaction will speed up, eventually removing all traces. 3. Apply alcohol: Brush alcohol onto the adhesive on the glass, and you'll see it slowly soften. Gently peel it off by hand, and the adhesive will come off easily. 4. Use hand cream: Apply hand cream to the adhesive area, wait for at least an hour (longer for better results), then gently scrape it off with a bank card for a clean removal.
12
2
Share

What are the differences between the Lynk & Co 03 and 03+?

The Lynk & Co 03 and 03+ are two sedan models under the Lynk & Co brand, with the following differences: 1. Exterior: The Lynk & Co 03 largely maintains the brand's family design language, featuring split-type headlight clusters, a horizontal front grille, and lower trim strips. The Lynk & Co 03+ undergoes further aerodynamic upgrades, with a full carbon fiber sports kit including the front bumper, side skirts, and rear spoiler. 2. Interior: The Lynk & Co 03 adheres to the brand's signature design, featuring a wraparound sporty cockpit, a driver-centric integrated smart center console, race-inspired air vents, and a D-shaped sport steering wheel. The three-spoke steering wheel comes with multifunction buttons and is paired with a digital instrument cluster. The gear shift area includes an electronic parking brake and a driving mode selector knob. The Lynk & Co 03+ incorporates racing-inspired elements on top of the base 03 model. The interior adopts a dual-tone black and yellow color scheme, with extensive use of Alcantara material. Details such as the steering wheel, gear knob, and seats feature the '+' logo.
3
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.