How to Heat and Modify Car Seats?
2 Answers
Turn off the car's power and check if the car key is in the off position. Use tools to remove the car seat where the heating system will be installed. Remember the disassembly sequence, determine the placement of the car seat heating pad, and place the side of the heating pad with the grid adhesive facing down, attaching it to the foam cushion. Slowly peel off the grid adhesive from one end while sticking it down. For areas with tension straps on the foam cushion, insert the heating pad into the bottom of the tension strap groove, keeping it flush with the bottom of the groove. Attach the wear-resistant tape inside the tension strap groove. Ensure the heating pad remains smooth without any wrinkles. Route the car seat heating pad wiring harness from the rear of the foam cushion and connect it to the main wiring harness. Test the constant power wire, ignition wire, and night driving wire with a test pen or multimeter two or more times to confirm accuracy before connecting. Secure the ground wire to the grounding screw.
Installing seat heating is actually not difficult, and the most common method I use is the electric heating pad solution. First, purchase carbon fiber heating pads designed for your specific car model, making sure to choose 12V voltage ones. Be careful with the clips when removing the seat, then insert the heating pad between the original foam and leather, installing it on both the backrest and seat cushion. For wiring, route it to the center console area to install a control switch, and the safest way is to connect it to the cigarette lighter circuit with a fuse. After installation, test the heating speed—it usually warms up in just a few seconds. Remember, waterproofing is crucial; last time I spilled coffee on the seat, but thankfully the heating pad was splash-proof. This method provides even heating and is energy-efficient, but DIY installation may take three to four hours.
