How to Handle Vehicle Inspection Overdue

Does the outdoor unit of an air conditioner blowing directly at a car have any impact?

It is not advisable for the outdoor unit of an air conditioner to blow directly at a car. During cooling, the outdoor unit is responsible for expelling heat. If two air conditioners are turned on simultaneously, their outdoor units will blow hot air towards each other, resulting in poor heat dissipation for each unit. This leads to higher power consumption in the air conditioning system and reduced cooling efficiency. Here is additional information: Air Conditioner: During cooling, the outdoor unit expels heat. If two air conditioners are operating at the same time, their outdoor units will blow hot air towards each other, causing poor heat dissipation for each unit. This results in higher power consumption in the air conditioning system and reduced cooling efficiency. Furthermore, the compressor may frequently enter protection mode.

1

3

Share

How to Solve the Abnormal Noise of the Power Steering Pump?

If there is abnormal noise in the power steering pump, the filter should be cleaned or the pump should be re-secured. Below are the specific reasons for weakened power steering in a car: 1. Dirty power steering fluid: The fluid acts as a force-transmitting medium. If the fluid is too dirty, it can cause poor circulation, making steering difficult. In severe cases, the power steering pump may also produce abnormal noise. 2. Insufficient or leaking power steering fluid: Lack of fluid means lack of power assistance. Check the related systems for any signs of leaks. Pay special attention to the power steering fluid reservoir, fluid lines, and steering gear. 3. Loose or tight power steering belt: Alternatively, the belt may be worn out. The tension can be adjusted, but a worn belt must be replaced.

20

1

Share

What are China III and China IV Vehicles?

China III and China IV vehicles are motor vehicles that comply with China's automotive emission standards. The following are the key differences between China III and China IV: 1. China III refers to the third stage of China's automotive emission standards, which introduced upgrades and modifications to engines and exhaust systems to reduce pollutant emissions, including enhancements to vehicle self-diagnostic systems. 2. China IV represents the fourth stage of China's automotive emission standards, featuring further upgrades to the post-emission treatment systems compared to China III, with pollutant emission standards reduced by 50% to 60% relative to China III. 3. To stably meet the China III emission standards, vehicles must be equipped with technical measures that ensure pollutant emissions comply with China III standards, along with the use of fuel that meets Euro III standards.

9

2

Share

Can LNG be added to CNG?

In principle, it is possible to add, but if a car chooses either LNG or CNG as fuel, the corresponding system will be installed. If you want to change the type of fuel for the car, it is best to first replace the corresponding gas injection system kit, because the kits required for installation on the car are different for each. The following is an introduction to the relevant knowledge about LNG and CNG: 1. Definition: Both LNG and CNG vehicles use natural gas as fuel and belong to clean energy vehicles. 2. Composition: The main component of the fuel is methane, and the two are very similar in terms of physical and chemical properties, fuel economy, and calorific value; the exhaust emissions basically do not contain sulfides or particulate matter.

3

Share

How to Deactivate a Car Anti-Theft Device?

The methods to deactivate a car anti-theft device are as follows: 1. Remove the alarm fuse. Locate the car's fuse box, identify the alarm fuse, and then use professional tools to remove it. 2. Unlock the car with the key. Use the key to open the driver or passenger door, then wait for a few minutes; most alarms will automatically stop. 3. Turn off the alarm directly. Open the car engine hood, locate the alarm according to the car's operation manual, and then follow the instructions to deactivate it. The car anti-theft device is a high-tech security product that integrates GSM network digital mobile communication technology and GPS satellite positioning technology. In addition to its anti-theft functions, it also features mobile phone control, SMS positioning, remote monitoring, remote alarm, and full voice prompt operation.

10

4

Share

What Causes Steering Wheel Stiffness at High Speeds?

High-speed steering wheel stiffness may result from the following causes: 1. Input sensor failure, such as a malfunctioning optical grating angle measurement sensor, preventing the ECU from properly obtaining user control parameters. 2. ECU malfunction: Computational errors in the ECU itself may lead to vehicle control actions that contradict the driver's intentions. 3. Improper driving: Prolonged driving with an unbalanced vehicle body may cause deviations in the yaw angle sensor position. 4. Solutions: Minor steering wheel stiffness can sometimes be resolved by adjusting the steering wheel up and down before returning it to its original position. Alternatively, turning the steering wheel lock-to-lock several times while stationary may eliminate the stiffness. If these methods prove ineffective, it is advisable to promptly visit an authorized dealership for inspection and resolution.

8

5

Share

How to Handle Vehicle Inspection Overdue

Does the outdoor unit of an air conditioner blowing directly at a car have any impact?

How to Solve the Abnormal Noise of the Power Steering Pump?

What are China III and China IV Vehicles?

Can LNG be added to CNG?

How to Deactivate a Car Anti-Theft Device?

What Causes Steering Wheel Stiffness at High Speeds?

What is the difference between gear ratios 4.33 and 4.875?

What does the car start button represent?

Where is the emergency trunk release switch located on the Passat?

What are the differences between Odyssey RB1 and RB2?