How to handle an A2 driver's license with 12 points deducted?

1 Answers
VonAdalynn
07/29/25 2:47pm
A2 driver's license with 12 points deducted processing method: Within 30 days, go to the vehicle management office to handle the downgrade. The A2 driver's license permits driving tractor-trailers. A valid A2 license issued by the Chinese public security traffic police vehicle management authority allows driving heavy and medium-sized full trailers, semi-trailers, and also vehicles permitted by B1, B2, C1, C2, C3, C4, and M licenses. A driver's license is a document required by law for motor vehicle drivers. By learning to drive motor vehicles, mastering basic knowledge of traffic regulations and driving skills, and passing the exam, one can obtain the motor vehicle certificate. The driver's license allows nationwide examination and cross-regional subject tests.
Was this review help?
3
5
Share
More Forum Discussions

How to Identify Piston Slap?

Methods to identify piston slap are as follows: 1. At low speed, conduct a cylinder cut-off test for each cylinder. If the knocking sound reduces or disappears after cutting off, it indicates that cylinder is the source. 2. At idle speed, the piston slap is obvious and clear. As the engine temperature rises or the speed exceeds medium speed, the knocking sound weakens or disappears. 3. Remove the spark plug and inject a small amount of thick lubricating oil into the cylinder through the spark plug hole. After adding the lubricating oil, use the starter to rotate the crankshaft several times to fill the gap between the piston and cylinder wall with an oil film, then start the engine. If the knocking sound significantly weakens or disappears immediately after starting, but quickly reappears as the oil film is lost or burned, it confirms that cylinder is the source. 4. Use a long-handled screwdriver to touch the side of the engine block and listen for the sound. If the knocking sound is obvious and slightly vibrates, it confirms that cylinder is the source.
7
3
Share

Where is the oil flow check valve located on the Cruze?

The engine oil check valve on the Cruze is located behind the car's alternator. Here is some relevant information about the Cruze: 1. The Cruze is a compact sedan produced by SAIC-GM Chevrolet. As of July 2019, the models available on the market are the 2018 versions. 2. In terms of body structure, the Cruze includes both sedan and hatchback versions. The sedan version has body dimensions of 4666*1807*1460mm, while the hatchback version measures 4450*1807*1459mm. 3. In terms of powertrain, the Cruze offers two engine options: a 1.5L naturally aspirated engine and a 1.4L turbocharged engine. The 1.5L version delivers a maximum horsepower of 114hp, maximum power of 84kw, maximum torque of 146N-m, with a MIIT comprehensive fuel consumption of 5.9L/100km. The 1.4L version provides a maximum horsepower of 150hp, maximum power of 110kw, maximum torque of 240N-m, with a MIIT comprehensive fuel consumption of 5.7L/100km.
18
3
Share

Is the Curb Weight of a Car the Same as Its Total Weight?

The curb weight of a car is not the same as its total weight. Below is a detailed introduction to the curb weight of a car: 1. The so-called curb weight of a car refers to the weight of the car when it is fully equipped according to the factory's technical conditions (such as spare tires, tools, etc.) and all fluids are filled. This is an important design indicator for a car. This indicator must be both advanced and practical. It is closely related to the car's design level, manufacturing level, and industrialization level. 2. Under the same model conditions, the better the design method, the higher the production level, and the higher the level of industrialization, the lower the curb weight will be. 3. The gross vehicle weight (G) refers to the weight of the car when it is fully equipped and loaded with passengers (including the driver) and cargo as specified. 4. Gross vehicle weight = curb weight + driver and passenger weight + luggage weight. For buses, gross vehicle weight = curb weight + driver and passenger weight + luggage weight + accessory weight. For trucks, gross vehicle weight = curb weight + driver and assistant weight + luggage weight.
11
1
Share

Is It Normal for Water to Enter Both Front Headlights of the Changan Eado?

It is not normal for water to enter both front headlights of the Changan Eado. Water ingress in the headlights may be caused by cracks in the headlight, improper installation of the headlight rear cover, or aging/damage of the headlight sealing ring. It is recommended to contact the local 4S store for inspection and repair. The solutions are as follows: 1. Negotiate with the 4S store or the manufacturer. You can report the issue to the relevant department and wait patiently, while keeping your phone and other communication devices accessible for the manufacturer's staff to contact you. 2. Remove the headlight cover, thoroughly dry it, and then reseal the headlight cover, applying multiple layers of sealant. The technical part of this method involves removing the headlight cover. If you are not very skilled, it is advisable to have it handled by a professional repair shop for a more reliable solution.
13
1
Share

What are the reasons for the transmission warning light in Trumpchi vehicles?

There are many reasons why the transmission warning light in a Trumpchi vehicle may illuminate. It could be due to insufficient automatic transmission fluid, failure to increase speed caused by a slipping one-way clutch, or engine failure to start. Potential causes to check include oil leaks, ignition issues, or wiring faults. Below is relevant information about transmissions: 1. A transmission is a mechanism used to alter the speed and torque from the engine. It can fix or change the transmission ratio between the output shaft and input shaft in steps, also known as a gearbox. The transmission consists of a gear transmission mechanism and a control mechanism, with some vehicles also including a power take-off mechanism. Most transmission mechanisms use ordinary gear transmission, while some employ planetary gear transmission. Ordinary gear transmission mechanisms typically use sliding gears and synchronizers. 2. Mechanical transmissions primarily apply the speed reduction principle of gear transmission. The gearbox contains multiple sets of gear pairs with different transmission ratios. Gear shifting during driving is achieved by operating the control mechanism to engage different gears in the transmission. For example, at low speeds, gears with larger transmission ratios are engaged, while at high speeds, gears with smaller transmission ratios are used.
8
3
Share

Where is the truck heater switch valve located?

Truck heater switch valve is located on the central control panel of the dashboard. Specific steps to turn on the heater in a truck: The heater switch valve of a truck is generally located on the central control panel of the dashboard. When turning it on, note that it opens clockwise and closes counterclockwise. Also, make sure to rotate it fully into position when switching. Precautions for using the heater: If the heater emits an unusual or foul odor, promptly visit a repair shop for inspection to determine if there's an issue with the air conditioning system or bacterial growth causing air pollution. Inhaling such air can have adverse effects on health, so timely cleaning is essential.
14
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.