How to Handle a Tesla Model 3 Driving Through Waterlogged Roads?

1 Answers
LaJoy
07/28/25 2:42pm
Before entering a waterlogged section, always check the current ground clearance of your vehicle to ensure it is not lower than the water level. Gently apply the brakes to reduce the vehicle's speed as much as possible, while ensuring the speed is not too low to prevent the vehicle from stalling.
Was this review help?
9
1
Share
More Forum Discussions

What brand is Dongfeng Motors' engine?

The 2009 Yuxuan 2.0L manual luxury model uses the PSA RFN10LH3 Dongfeng engine, with a maximum horsepower of 147 hp, maximum power of 108 KW, maximum power speed of 6000 rpm, and peak torque of 200 N.m. The 2021 Rich 2.4L gasoline four-wheel-drive dream edition long cargo box 2TZD uses the 2TZD engine, with a maximum horsepower of 158 hp, maximum power of 116 KW, maximum power speed of 5000 rpm, and peak torque of 235 N.m. The Dongfeng Fengguang 580 engine is produced in Shiyan, Hubei. The Dongfeng Fengguang 580 engine is built with Fiat technology. For daily maintenance of Dongfeng engines, the following methods can be used: Use lubricating oil of appropriate quality grade. For gasoline engines, SD--SF grade gasoline engine oil should be selected based on the additional devices of the intake and exhaust systems and usage conditions; for diesel engines, CB--CD grade diesel engine oil should be selected based on mechanical load, with the selection standard not lower than the manufacturer's requirements. Regularly change the oil and filter. The quality of any grade of lubricating oil will change during use. After a certain mileage, performance deteriorates, leading to various engine problems. To avoid faults, change the oil regularly according to usage conditions and keep the oil volume moderate. When oil passes through the fine holes of the filter, solid particles and viscous substances in the oil accumulate in the filter. If the filter is blocked and oil cannot pass through the filter element, the filter element may burst or the safety valve may open, allowing oil to pass through the bypass valve and bring contaminants back to the lubrication area, accelerating engine wear and increasing internal pollution. Regularly clean the crankcase. During engine operation, high-pressure unburned gas, acid, moisture, sulfur, and nitrogen oxides from the combustion chamber enter the crankcase through the gap between the piston rings and cylinder walls, mixing with metal powder from part wear to form sludge. When the amount is small, it suspends in the oil; when large, it precipitates from the oil, clogging filters and oil holes, making engine lubrication difficult and causing wear. Regularly use a radiator cleaner to clean the radiator. Removing rust and scale not only ensures the engine works properly but also extends the overall lifespan of the radiator and engine.
6
2
Share

Why is the Buick LaCrosse not holding its value?

The most important reason is that Buick's brand power currently cannot support the price of this mid-size sedan, giving it a somewhat 'neither here nor there' feeling. Additionally, the fuel consumption of this car is indeed relatively high, whether it's the new or old models. Below are specific details about the Buick LaCrosse: 1. Vehicle Design: The Buick LaCrosse adopts Buick's latest family design language, featuring smooth and elegant body lines and a dynamic body proportion. The wing-shaped full LED automatic sensing headlights use advanced light curtain technology to create a more uniform and brighter illumination effect. With a body length of 5026mm, width of 1866mm, height of 1462mm, and a wheelbase of 2905mm, it offers a spacious driving and riding space typical of a large premium sedan, providing a comfortable and relaxed seating posture. The interior includes 29 practical storage spaces, making it convenient to store commonly used devices and handbags. 2. Powertrain: The 2021 Buick LaCrosse family is equipped with two sets of driving systems, combining powerful performance with excellent fuel economy, and all models meet the 'China VI b' emission standards. 3. Safety Features: The 2021 Buick LaCrosse adds a second-generation high-definition streaming media rearview mirror, supporting one-key switching between a traditional rearview mirror and streaming media. It also features adaptive brightness adjustment, field of view zoom, and vertical angle adjustment, providing a rear view range three times that of a traditional rearview mirror and significantly improving the clarity of rear images during nighttime driving.
14
5
Share

How to Reset the Maintenance Light on a Chevrolet Malibu?

To reset the maintenance light on a Chevrolet Malibu, follow these steps: 1. With the engine off, turn the ignition switch to the "Ignition/Run/Start" mode. 2. Use the buttons on the right side of the steering wheel in the Driver Information Center area to control the instrument panel display to show the "Oil Life" screen. When the remaining oil life is low, the display will show a "Change Engine Oil Soon" message. 3. Press the ">" button on the Driver Information Center controller, and the display will show "Reset." Then press the "√" (OK/Confirm) button to reset the oil life to 100%. 4. Turn off the ignition switch to complete the reset.
4
3
Share

How many kilometers can a full tank of fuel run for the CT5?

Normally, a full tank of fuel can run about 500 kilometers. The Cadillac CT5 has a combined fuel consumption of 7.2L per 100 kilometers. The following is an introduction to the fuel consumption per 100 kilometers: 1. Meaning: Fuel consumption per 100 kilometers refers to the fuel consumption of a vehicle traveling 100 kilometers on the road at a certain speed. It is a theoretical indicator of the vehicle. The fuel consumption per 100 kilometers is a value measured by the manufacturer in an objective environment using a dynamometer installed on the vehicle's chassis, converted into speed parameters, and then specified speed driving to calculate the theoretical experimental fuel consumption data per 100 kilometers of the model. 2. Actual fuel consumption: Since most vehicles are close to the economical speed at 90 kilometers per hour, most of the publicly announced theoretical fuel consumption is usually the fuel consumption per 100 kilometers at 90 kilometers per hour.
1
3
Share

How to Use the Traffic Management 12123 App to Deduct Points for Someone Else's Vehicle?

You need to bind a non-personal motor vehicle in the Traffic Management 12123 APP and upload personal identification documents for verification to deduct points on behalf of others. More relevant information is as follows: Note 1: In one scoring cycle, a maximum of three driver's licenses can be used to deduct points for one motor vehicle; one driver's license can only deduct points for the violation records of up to three motor vehicles within one scoring cycle. If more than three driver's licenses are used or more than three motor vehicles' violation records are processed, the user will be listed as a key review target and their point deduction service will be suspended. Note 2: Accepting penalties and point deductions on behalf of the actual driver and profiting from it will result in a 6-month suspension of the driver's license and a fine for the first offense; for repeated offenses or organizing/introducing others to do so, the offender will face up to 15 days of detention, a fine, revocation of the motor vehicle driver's license, and a five-year ban from obtaining a driver's license. Any illegal gains will be confiscated.
3
3
Share

How to Turn On the Low Beam and High Beam?

Here is the introduction to the method of turning on the car's low beam and high beam: 1. First, turn on the vehicle's low beam (some vehicles have a knob, while others have a light lever). For the left lever, twisting the head upward turns on the low beam. 2. After turning on the low beam, pushing the lever downward activates the high beam, lifting it turns on the low beam, and pulling it forward makes the high beam flash once. Additional information: 1. The high beam icon is blue with a straight line shape; the low beam icon is green with a line slanting downward. 2. There is a lever on each side of the steering wheel. The right one is mostly for wiper control, while the left one is mostly for light control, including switching between high and low beams, and turn signal control. 3. For the combined light control lever, the high and low beams are toggled by moving the lever up and down, while the turn signal is toggled by moving it forward and backward.
1
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.