How to Handle 12 Points Deducted for Driving a Motorcycle with a C1 License?

What is the fuel tank capacity of the 2017 Honda CR-V in liters?

The fuel tank capacity of the 2017 Honda CR-V 240TURBO Manual 2WD Classic is 57L. It is equipped with a 1.5L turbocharged engine and a 6-speed manual transmission (MT). The drivetrain is front-engine, front-wheel drive. The front suspension is a MacPherson independent suspension, and the rear suspension is a multi-link independent suspension. Among vehicles in the same class, the 2022 Tayron 280TSI 2WD Luxury Smart Connect Edition has a fuel tank capacity of 60L, while the 2021 RAV4 2.0L CVT 2WD Urban Edition has a fuel tank capacity of 55L. During actual refueling, the amount of fuel may exceed the marked capacity. This is because the fuel tank capacity specified by the manufacturer is measured from the bottom of the tank to the safety limit, and there is additional space from the safety limit to the tank opening. This space ensures that the fuel can expand when temperatures rise without overflowing. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked capacity. To check the remaining fuel level, drivers can observe the fuel gauge on the right side of the dashboard, which is marked with 'E' and 'F'. When the needle is close to 'E', it indicates low fuel, and when it is near 'F', it means the tank is full.

4

0

Share

What to Fill in for License Plate Type?

License plate type refers to the abbreviation of provinces/autonomous regions/municipalities directly under the central government. According to the provincial capital code and the first letter of the license plate, the letter represents the code of the city where the vehicle is registered. 'A' stands for the provincial capital, while 'O' indicates license plates issued by the vehicle management office directly under the public security department, generally for vehicles registered in the provincial capital. The type of motor vehicle can be distinguished by the color and font of the license plate: Black border with black characters at the bottom: Special license plates for new energy vehicles. New energy vehicle plates are gradually turning green, with large new energy vehicle plates being yellow-green. Black border with yellow and black characters: Large license plates, medium and above passenger vehicles, cargo trucks, special operation vehicles, semi-trailer tractors, and trams. Black border with yellow and black characters: License plates for trailers not fixed to tractors, full trailers, and semi-trailers. Generally, cars over 6 meters also need to be reserved. White border with blue and white characters: Small license plates, medium buses, trucks, and special operation vehicles. License plates are distinguished by alphanumeric characters. The first character of the license plate is in Chinese: the abbreviation of the province where the vehicle is registered. The second character is in English: the primary code of the city where the vehicle is registered. 'A' is the provincial capital, 'B' is the second-largest city. Each province and city is different, and the letters are not in order.

18

3

Share

What are the functions and principles of brake fluid?

Here is a detailed introduction to the functions and working principles of brake fluid: 1. Function: Brake fluid is a liquid medium that transmits braking pressure in hydraulic braking systems, used in vehicles equipped with hydraulic braking systems. Brake fluid, also known as braking oil or force oil, is an indispensable part of the braking system. Within the braking system, it serves as a medium for force transmission. Since liquids cannot be compressed, the pressure output from the master cylinder is directly transmitted to the wheel cylinders through the brake fluid. 2. Principle: In a sealed container or a pipeline filled with liquid, when the liquid is subjected to pressure, the pressure is quickly and evenly transmitted to all parts of the liquid. Hydraulic braking operates based on this principle.

2

0

Share

What are the reasons for difficult starting of air-cooled diesel engines?

Difficult starting of an air-cooled diesel engine is often due to issues with the fuel injection timing. To address this, readjust the injection timing by removing the flywheel housing and rotating the flywheel to observe the fuel injection pump. When the notch on the cylinder head aligns with the 20-degree mark on the flywheel, the fuel injection pump should just begin to emit fuel. If not, adjust by adding or removing copper shims from the fuel pump. Methods to address difficult starting of air-cooled diesel engines: 1. Preheating during cold seasons: During cold starts, diesel engines often fail to reach the compression ignition temperature of diesel, which is a primary reason for starting difficulties. A practical solution is to add hot water to the engine cooling system for preheating, effectively improving starting performance. 2. Improve cylinder sealing performance: One key difference between diesel and gasoline engines is the compression ignition method, which requires higher cylinder sealing performance. During cold starts, the lack of sufficient oil between piston rings and cylinder walls leads to poor sealing, resulting in repeated failed start attempts. Severe cylinder wear can further degrade sealing performance, making starting even more difficult. 3. Remove air from the fuel system: Loosen the air bleed screw on the high-pressure fuel pump and manually pump fuel to expel air from the high-pressure fuel lines. Then, loosen the fuel pipe connections on each injector, set the throttle to maximum fuel supply position, and crank the engine until fuel flows steadily from each injector's fuel pipe connection.

7

0

Share

What causes the pressure drop at the throttle connection of the Passat turbocharger?

Passat turbocharger throttle connection pressure drop is caused by a damaged exhaust one-way valve or a leaking boost pipe. The reasons for insufficient turbocharger pressure are as follows: Air filter blockage: Blockage of the turbocharger's air filter increases suction loss, resulting in insufficient boost pressure; Excessive oil deposits: Excessive oil deposits in the compressor's internal air passages increase airflow resistance, leading to reduced boost pressure; Poor fuel combustion: Poor fuel combustion causes carbon buildup on the rotor or increased rotational resistance due to turbocharger bearing damage, both of which can result in decreased boost pressure.

7

3

Share

How to Lower a Car's Body?

First, you need to be clear about your purpose for modifying the car or the goal you want to achieve, such as making it a cornering beast, a straight-line monster, or simply for appearance. If it's purely for appearance, the only downside is that after lowering the body, the suspension geometry painstakingly set by the original engineers is disrupted, and the stress on suspension components changes, potentially making them more prone to damage, creating annoying noises, and other issues. If your goal is to improve handling, I advise you to either keep it stock or seek out highly professional individuals to modify your car. There's a saying in the modification world: 'Lower it, and a hundred flaws disappear.' This isn't entirely false. However, when browsing forums and communities, we often see many car enthusiasts who have lowered their cars mention that after lowering, they feel the handling has improved, lane changes feel more confident, and so on. The real reason isn't that the handling has improved but that lowering the body lowers the center of gravity, reducing the car's body roll. However, reduced body roll doesn't necessarily mean better handling. Good handling means that during turns, the tires maintain a larger contact patch with the road, providing stronger grip—that's what good handling is. After simply changing the springs and shocks to lower the car, theoretically, the handling should worsen. Why is that? Because the suspension geometry is compromised. Although body roll is reduced, giving a greater sense of security, the margin for error for the tires becomes smaller, meaning the window for recovery is narrower.

18

2

Share

How to Handle 12 Points Deducted for Driving a Motorcycle with a C1 License?

What is the fuel tank capacity of the 2017 Honda CR-V in liters?

What to Fill in for License Plate Type?

What are the functions and principles of brake fluid?

What are the reasons for difficult starting of air-cooled diesel engines?

What causes the pressure drop at the throttle connection of the Passat turbocharger?

How to Lower a Car's Body?

Can I pass the driver's license renewal physical examination with color weakness?

Why does the car jerk when pressing the accelerator?

What are the sounds of inner CV joint damage?

What is the difference between the internal circulation and external circulation of a vehicle?