···
Log in / Register

How to get out when the distance between the front and rear cars is too small?

4 Answers
StCayden
07/29/25 10:57pm

If the distance between the front and rear cars is too small, you can get close to either the front or rear car, then accelerate carefully to create enough space to get out. This method might work for smaller cars. However, if the car is too large or the space is too tight, it can be quite challenging. Therefore, judging the distance between the front and rear cars is crucial after starting to drive. More details are as follows: 1. Right rearview mirror: Use the rearview mirror to estimate the distance of the car behind. If the rear car fills the entire right rearview mirror, the distance between the two cars is approximately three meters. However, if the rear car fills the left rearview mirror, the actual distance is only about one meter. At this distance, it is too close for any overtaking or lane-changing maneuvers. 2. Left rearview mirror: If the rear car fills half of the left rearview mirror, the distance is roughly five meters, while for the right rearview mirror, it is about nine meters. This distance is relatively safer.

Was this review help?
7
1
Share
MacJasmine
08/16/25 12:40am

I was once sandwiched like this in a mall parking lot with minimal space between cars, barely able to move. I slowly tried turning the steering wheel while reversing, making slight angle adjustments to ensure I could see the distance to the rear car in the mirrors. If the space was really tight, I had to go back and forth a few times, turning the wheels repeatedly to inch out some room. Remember not to rush during the whole process—it’s easy to scrape—and avoid honking to disturb others. Stay patient, and you’ll eventually get out. It’s even better if someone steps out to help guide you, but most times, you’ll have to rely on yourself to inch out safely. Safety first. After practicing a few times, you won’t panic over such small challenges anymore.

Was this review help?
9
1
Share
Expand All
Pedro
10/18/25 5:53am

Years of driving experience have taught me that small gaps between cars can indeed be tricky, but with the right approach, it's manageable. The key is to make full use of the steering system—first turn the wheel towards the side with more space, then slowly reverse, and the car body will gradually move out of the gap. Simultaneously, check blind spots and rely on the reversing radar to avoid scraping. If the car doesn't budge, don't force it; move forward slightly to create more space before trying again. Additionally, keep the speed extremely slow—just a few centimeters per second—for better control. In such situations, staying calm is crucial; don't let anxiety take over your driving.

Was this review help?
10
0
Share
Expand All
LaZoe
12/01/25 6:32am

Safety is always the top priority, and never take risks when the distance between cars is too small. I will first ensure the engine starts normally, then check for pedestrians or obstacles around, and finally reverse with minimal steering wheel movement. Keep an eye on the rearview mirror at all times to confirm the gap. If there's any perceived risk, pause and wait, seeking help if necessary. Avoid sudden acceleration or sharp turns in tight spaces, as this increases the chance of scratches. Every successful exit is a form of practice, and accumulating experience naturally leads to better handling.

Was this review help?
4
1
Share
Expand All
More Forum Discussions

What is the issue with the Audi hydraulic oil elbow bushing noise?

Audi hydraulic oil elbow bushing noise issue is caused by valve oil leakage and joint detachment. Below is the relevant introduction: 1. Introduction: Audi is a renowned car developer and manufacturer, with its logo featuring four interlocking rings. It is now a subsidiary of Volkswagen Group, headquartered in Ingolstadt, Germany. 2. Main models: Audi A1, Audi A3, Audi A4, Audi A5, Audi A6, Audi A7, Audi A8, Audi Q1, Audi Q2, Audi Q3, Audi Q5, Audi Q7, Audi Q8, Audi TT, Audi R8, and the S, RS performance series, etc.
17
2
Share

Why are second-hand Besturn B50 cars so cheap?

First, the pricing is not high; second, the sales of new cars are not good, with continuous price reductions leading to depreciation of used cars; third, the marketing is poor. Additional information is as follows: 1. In terms of comfort: The Besturn B50 continues to optimize vibration and noise control, achieving improvements in areas such as passing noise and constant-speed driving vibration noise, enhancing the quietness of the cabin space. At the same time, the Besturn B50 is also equipped with an audio system configuration, such as the addition of an AUX interface, forming two external audio source playback functions with USB, providing users with more choices. 2. In terms of configuration: The Besturn B50 adds a cornering assist lighting system, which can automatically control the cornering lights (front fog lights) based on changes in driving conditions and vehicle status. In addition, new safety equipment includes a reminder for the front passenger seatbelt not being fastened, anti-whiplash seats, full hidden airbags, central locking, and headlight level adjustment.
1
5
Share

Tesla's Maximum Wading Depth?

Tesla's maximum wading depth is 138mm. Tesla's wading depth is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake is below the water level when wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. Alternatively, installing a wading snorkel can increase the height of the engine's air intake, thereby increasing the maximum wading depth. If wading is unavoidable, the following safe and correct operations should be performed: Before wading, always turn off the auto start-stop function to prevent the engine from automatically restarting after stalling in water, which could lead to severe damage if water enters the engine. Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, use warning water level markers, trees, or other vehicles' wheels and doors as reference points to estimate water depth before deciding whether to proceed. Know your vehicle's safe wading depth. If the water depth exceeds half the tire height or the engine's air intake, avoid entering the water and choose an alternative route instead.
11
4
Share

Should the Nissan Sylphy ECO Mode Be Turned On?

In congested urban traffic conditions, turning on the ECO mode yields the best results, while it is unnecessary during high-speed driving. In stop-and-go city traffic, strong power is not required, and frequent acceleration and braking lead to higher fuel consumption. Activating the ECO mode in such scenarios not only reduces fuel consumption but also enhances driving comfort. Scenarios where ECO mode is unnecessary: There are a few situations where ECO mode is not needed: 1. When the car is driving at high speeds (up to 100km/h), even if ECO is turned on, the vehicle's computer will prioritize speed, causing the ECO mode to automatically deactivate. 2. When high torque output is required, such as when climbing hills, the engine computer will prioritize delivering sufficient power to drive the vehicle, and the ECO mode will automatically deactivate. Location of the ECO button: The ECO button is typically located on the left side of the car, marked with the letters 'ECO.' Some models feature a green button, making it easily identifiable.
12
2
Share

Do I Need to Change to Snow Tires When Driving to Northeast China During the Spring Festival?

Driving to Northeast China requires snow tires, as their grip performance is significantly better than regular summer tires or all-season tires. If you encounter icy roads, most vehicles without snow tires will be unable to move. Snow tires help vehicles achieve optimal braking performance on winter roads. Snow tires, also known as winter tires, are made by adding certain additives to ordinary rubber during production, ensuring the tires do not harden significantly in winter. Regular tires tend to become very hard in winter, reducing their grip and making them prone to slipping in snowy conditions. The tread material of snow tires is softer, and their specially formulated silica-mixed rubber compound allows for tighter contact with smooth ice surfaces, generating greater friction than all-season tires. This improves the vehicle's handling and safety on icy roads. Tires are rubber products, and prolonged use leads to aging. Therefore, it is recommended that car owners replace their tires regularly. Generally, tires should be replaced every four years. When purchasing tires, make sure to check the production date clearly.
16
2
Share

Where is the China VI Emission Standard Implemented?

The China VI emission standard has been implemented ahead of schedule in regions such as Beijing-Tianjin-Hebei, Yangtze River Delta, Pearl River Delta, Chengdu-Chongqing, Fenwei Plain, and Inner Mongolia. Specific provinces and cities include Beijing, Tianjin, Hebei, Shanxi, Shandong, Henan, Shanghai, Jiangsu, Zhejiang, Anhui, Shaanxi, some cities in Inner Mongolia, Guangdong, Chongqing, Sichuan, and Hainan. The early implementation regions are based on national-level documents such as the 'Blue Sky Defense Battle' and the 'Action Plan for the Battle Against Pollution by Diesel Trucks,' combined with statistics, leading to the issuance of the 2019 document on the early implementation of the China VI standard in these provinces and cities. For light vehicles (such as cars, SUVs, pickup trucks, and micro trucks), the normal implementation time for the China VI standard is July 1, 2020. For general-purpose heavy-duty vehicles, the implementation date is July 1, 2021.
14
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.