How to Fold the Rearview Mirror?

1 Answers
OJoy
07/29/25 10:46pm
Methods for folding the rearview mirror: If the car has an automatic folding function when locked, you can operate it in the rearview mirror switch area to fold it; if there is no automatic folding function, you can simply fold it manually. Whether the car has this function can be determined by checking the knob for adjusting the rearview mirror angle inside the car. A small mirror icon indicates the presence of this function, while its absence means there is none. Many small ripples indicate the heating function for the left rearview mirror. The car rearview mirror reflects the situation behind, beside, and below the car, allowing the driver to see these areas indirectly. It acts as a second eye, expanding the driver's field of vision.
Was this review help?
18
0
Share
More Forum Discussions

How Often Should You Change the Oil If You Don't Drive for a Long Time?

If you don't drive for a long time, you should change the oil every six to eight months. Oil left in the engine oil pan for an extended period can oxidize and deteriorate. Oil is often referred to as the lifeblood of the engine, as it plays crucial roles in lubrication, cleaning, sealing, heat dissipation, buffering, and rust prevention. Without oil, the engine cannot function properly. There are three types of engine oil: full synthetic oil, semi-synthetic oil, and mineral oil. Full synthetic oil offers superior lubrication performance and a longer service life. Engine oil consists of base oil and additives, with common additives including dispersants and antioxidants. While the base oils used by different brands are generally similar, the key difference lies in the formulation of the additives, which represents the core technology of oil manufacturers.
11
1
Share

How to Adjust the Wiper Intermittent Interval?

Wiper intermittent interval adjustment method: There is a speed adjustment knob on the wiper lever, which can be used to adjust the intermittent interval of the wiper. The speed adjustment knob has several gears. When the wiper is in the intermittent mode, the speed (wiper frequency) adjusted by the knob changes step by step. The wiper, also known as a windscreen wiper, is a device used to wipe off raindrops and dust attached to the vehicle's windshield, improving the driver's visibility and increasing driving safety. The power source of the wiper comes from the motor, which is the core of the entire wiper system. The quality requirements for the wiper motor are very high, using a DC permanent magnet motor. The wiper motor installed on the front windshield is integrated with the worm gear mechanical part. The function of the worm gear mechanism is to reduce speed and increase torque. Its output shaft drives the four-bar linkage mechanism, which converts continuous rotational motion into left-right swinging motion.
7
5
Share

What car has a logo with a horse?

Cars with logos featuring a horse include Ferrari, Ford Mustang, Porsche, Baojun, and Carlsson. Ferrari's logo is a black prancing horse on a yellow background; the Ford Mustang displays a silver running horse; Porsche's emblem is a shield-shaped logo with a leaping horse inside. Ferrari is a manufacturer from Italy, and the Ferrari F12 is a front-engine GT sports car in its lineup. The dimensions of this car are 4618 mm in length, 1942 mm in width, and 1273 mm in height, with a wheelbase of 2720 mm. The car's 6.3-liter V12 naturally aspirated engine delivers a maximum power of 545 kW, with the maximum power achieved at 8250 rpm and maximum torque at 6000 rpm. This engine is equipped with direct fuel injection technology and uses an aluminum alloy cylinder head and block.
18
2
Share

Do I Need a Wheel Alignment After Changing Tires?

Replacing tires does not require a wheel alignment. After changing tires, wheel balancing is necessary, which is unrelated to wheel alignment. If the vehicle does not pull to one side while driving and the steering wheel remains straight, then alignment is not needed. However, wheel balancing must be performed; otherwise, the vehicle may experience shaking during driving. If you notice heavy steering, shaking, pulling to one side, misalignment, or failure to return to center, or abnormal tire wear such as uneven wear, scalloped wear, cupping, or excessive wear on one side, or if you experience floating, bumping, or swaying sensations while driving, it is advisable to check the wheel alignment values to see if they are significantly off and to perform timely repairs.
6
1
Share

Where is the windshield washer fluid reservoir located on the Buick Verano?

Buick Verano windshield washer fluid reservoir location: On the left side of the engine compartment, there is a small blue-capped container with a windshield washer symbol on its lid - this is the washer fluid reservoir. Open it and pour in the antifreeze washer fluid, but do not overfill it; just fill until you can slightly see the fluid level at the very top. The Buick Verano is a compact sedan under the Buick brand, with a wheelbase of 2700 mm and dimensions of 4723 mm in length, 1802 mm in width, and 1466 mm in height. In terms of powertrain, the Verano is equipped with two engine options: a 1.0-liter turbocharged engine producing 125 horsepower and 180 Nm of maximum torque, and a 1.3-liter turbocharged engine delivering 165 horsepower and 240 Nm of maximum torque. Both engines feature direct fuel injection technology and utilize aluminum alloy cylinder heads and blocks.
12
3
Share

What Are the Symptoms of a Slipping Car Clutch?

Symptoms of a slipping car clutch: 1. When starting the car, even after fully releasing the clutch pedal, you still feel insufficient power or difficulty in starting; 2. While driving, the vehicle speed does not increase correspondingly with the rise in engine RPM, resulting in poor driving performance; 3. When the car is heavily loaded or driving uphill, or on muddy and soft roads, the slipping becomes more obvious, and in severe cases, a burning smell may emanate from the clutch. Causes of clutch slipping: 1. The clutch pedal free play is too small, and the release bearing frequently presses against the diaphragm spring, keeping the pressure plate in a semi-engaged state; 2. The clutch pressure plate spring is too weak or broken, or the screws connecting the clutch to the flywheel are loose, all of which can cause the clutch to slip.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.