How to Fix Water Dripping from the Lavida Sunroof Reading Light?

1 Answers
DeJasper
07/29/25 8:22pm
Go quickly to a place where they change tires, take an air gun, and aim it at the drainage holes of the two front drainage pipes inside the sunroof. Use high-pressure airflow to blow through the drainage pipes. After blowing, pour water into the sunroof and check if water flows out from the sunroof drainage outlets under the two front wheels. If it does, the drainage pipes will be unclogged.
Was this review help?
18
5
Share
More Forum Discussions

How to Refill Car Refrigerant?

Refilling refrigerant can be done from either the high-pressure side or the low-pressure side. High-pressure side refilling involves adding liquid refrigerant, which is suitable after leak detection and vacuuming. Note that the compressor must not be turned on during this method, the engine should be off, and the refrigerant can must be inverted. Here is additional information: Low-pressure side refrigerant refilling method: First, connect the manifold gauge set to the compressor and the refrigerant can. Open the refrigerant can, loosen the nut on the middle injection hose connected to the manifold gauge set until you hear the sound of refrigerant vapor flowing, then tighten the nut to expel air from the injection hose.
12
2
Share

What is the Difference Between China IV and China V?

Here are the differences between China IV and China V: Differences in Emission Standards: Compared to China IV emission standards, China V is more stringent, with fewer pollutants emitted, making it more environmentally friendly. Differences in Control Systems: China V, compared to China IV, mainly features a more complex emission control system, resulting in increased costs. Differences in Pollution Levels: To further reduce photochemical pollution caused by gasoline evaporation emissions and decrease deposits in car engine intake systems, the olefin content has been reduced from 28% in the fourth stage to 24%. Solid suspended particles are complex in composition and have strong adsorption capabilities, capable of adsorbing various metal dust, highly carcinogenic substances like benzopyrene, and pathogenic microorganisms. These solid suspended particles enter the human lungs through respiration and remain in different parts of the respiratory tract through collision, diffusion, and deposition, leading to respiratory diseases.
16
4
Share

Reasons for the Engine Warning Light in a New Haval H6

There are seven main reasons why the engine warning light may illuminate in a Haval H6: Sensor malfunction: The sensors in question include those for coolant temperature, crankshaft position, air flow, intake temperature, and oxygen sensors. When these sensors are damaged, have poor contact, or their signals are interrupted, the vehicle's ECU cannot accurately obtain engine data, which can trigger the engine warning light. Fuel or oil quality issues: Failure to use the fuel or engine oil as specified by the manufacturer may cause engine wear, leading to the illumination of the warning light. Poor combustion of the air-fuel mixture: Poor combustion can result in engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the warning light will illuminate as a warning. Issues such as faulty spark plugs, ignition coils, fuel pumps, or clogged fuel lines can all lead to poor combustion. Turbocharger problems: Issues with the intake boost pipes or the turbocharger itself can also cause the engine warning light to come on. The most common problem is a damaged turbocharger, which may be accompanied by symptoms like oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Intake problems: If there are issues with the vehicle's air intake, it may lead to clogged engine pipes, and in severe cases, trigger the engine warning light. A dirty air filter that hasn't been cleaned regularly can cause intake problems. Exhaust problems: Exhaust system faults can also trigger the engine warning light. Common causes include faulty rear oxygen sensors, catalytic converters, exhaust camshafts, or bearings. The catalytic converter is the most frequent culprit. Using leaded gasoline, lead- or silicon-based lubricant additives, physical damage to the catalytic converter, or fuel system issues can all lead to catalytic converter failure. Anti-theft system malfunction: If the vehicle's electronic anti-theft system malfunctions or if there is a mismatch between the anti-theft controller and the engine ECU, the anti-theft system can prevent the engine from operating normally and trigger the engine warning light. If the engine warning light comes on, follow these steps: First, check whether the engine is running normally and if there are any issues such as shaking or black smoke. If so, avoid restarting the engine. Note: If the light is red, do not restart the engine under any circumstances. If the engine can be started, turn it off and wait 5-10 minutes. Without pressing the brake, press the start button once or turn the key halfway to the 'on' position (without pressing the clutch). The vehicle will enter self-diagnosis mode, and after 5-10 seconds, check if the warning light has turned off. If the warning light remains on, visit a service center as soon as possible. The service center can use a portable diagnostic tool to read the fault codes, identify the issue, and perform targeted repairs.
12
3
Share

What is the fuel consumption of the Highlander 2.0T?

The fuel consumption of the Highlander 2.0T is 9.6L/km. Below is a related introduction to the Toyota Highlander: Powertrain: It is equipped with a 3.5L V6 engine that delivers up to 201 kW of power, paired with a stepped 5-speed automatic transmission with manual mode, providing smooth acceleration, excellent fuel economy, and a delightful driving experience. Interior: The Highlander's interior features a simple and elegant design with numerous buttons on the center console, but they are well-arranged for easy operation. The craftsmanship is meticulous, with even seams, and the color scheme exudes a noble and elegant feel. It comes with rich configurations, making the interior highly practical overall.
5
4
Share

Can a Car with Temporary License Plates Drive on Highways?

Cross-administrative region temporary license plates are permitted for highway use. Placement requirements: Two temporary license plates must be affixed simultaneously: one should be placed in the lower left or right corner of the front windshield inside the vehicle where it does not obstruct the driver's view, and the other should be affixed to the lower left corner of the rear windshield inside the vehicle. For other types of vehicles where installation conditions are limited, only one temporary license plate is required, but it must be placed in the lower left or right corner of the front windshield inside the vehicle without obstructing the driver's view to ensure driving safety. Categories: There are four types: Temporary license plates for administrative regions, cross-administrative region temporary license plates, temporary license plates for testing purposes, and temporary license plates for special-type motor vehicles.
1
3
Share

How Long Should You Wait Before Taking a New Car on the Highway?

New cars can be taken on the highway after completing a break-in period of 3,000 kilometers. Below are some key considerations for breaking in a new car: Avoid Emergency Braking: Emergency braking not only shocks the braking system during the break-in period but also increases the impact load on the chassis and engine. It is recommended to avoid emergency braking within the first 300 kilometers of driving. Avoid Overloading: If a new car is overloaded during the break-in period, it can cause damage to mechanical components. For the first 1,000 kilometers, the load should generally not exceed 75%-80% of the rated capacity.
11
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.