How to Fix the Auto Hold Malfunction in Haval H2?

1 Answers
Hank
07/29/25 4:04pm
After driving for a certain distance, if you feel the surface of the brake drum is hot to the touch, it indicates that the brake drum clearance is too small and needs readjustment. Generally, the clearance should be between 0.2 to 0.4mm. Enter the vehicle, then press the foot brake, hold down the electronic handbrake for 5 seconds, and then pull up the electronic handbrake for another 5 seconds. This will initialize and reset the electronic handbrake. The parking brake is the manual brake installed in motor vehicles. If the auto hold system is damaged, the handbrake can be used as a substitute. The handbrake is usually located at the right-hand side of the driver. If no issues are found or the issues cannot be resolved, immediately drive to an auto repair shop for maintenance.
Was this review help?
8
5
Share
More Forum Discussions

How to Deal with Occupying Someone Else's Parking Space?

First, contact the property management to verify the owner of the vehicle. If necessary, review surveillance footage to identify the person. Request the property management to call the unfamiliar car owner and ask them to move the vehicle. If the car is not moved for an extended period, demand prompt action from the property management. If the property management fails to act, report to the police and hold both the car owner and property management accountable.
5
3
Share

How to Remove Chain Grease?

Use a degreaser to remove the grease, then rinse with water, spray a bicycle-specific rust inhibitor, and let it air dry naturally before adding a small amount of lubricating oil. Pour dishwashing liquid onto the greasy area, use a small toothbrush to scrub back and forth along the fabric grain, and then wash with laundry detergent.
16
5
Share

How to reset the tire pressure on a Lexus ES?

Under the steering wheel and above the brake pedal, you will feel a small round button when you reach in. Press and hold it. Hold until the tire pressure monitoring yellow light on the dashboard flashes three times, then release. This indicates that the tire pressure monitoring reset is successful. After resetting, the pressure values may not display immediately when checking the tire pressure. They will typically appear after driving for a while or keeping the power on for a certain period.
13
4
Share

How to Use a Lift Vehicle?

Before use, first check the lift platform for any abnormalities; Move the lift platform to the work location, connect the power supply, and extend the support legs of the lift platform until it is level; Turn on the electrical control switch of the lift platform to check if the power is connected; The operator should carry tools into the lift platform and close the protective door; use the lift and lower buttons on the control handle of the lift platform to perform the lifting operation.
3
4
Share

What to Do When the Key Gets Stuck?

Use a syringe to draw a small amount of lubricating oil, align the syringe needle with the key groove, and slowly inject a small amount of lubricating oil. Gently turn the key a few times to evenly lubricate the interior, then inject a small amount of lubricating oil into the groove on the other side of the key, and turn the key a few more times.
3
0
Share

What to Do If the Vehicle License Has Expired Without Renewal?

The traffic management department does not need to inspect the vehicle; they only need to review the inspection application form, ID card, driving license, compulsory insurance certificate, and vehicle and vessel tax proof. You will need to drive the vehicle to the inspection station for a vehicle check. Only after passing the inspection can you proceed to the designated window to apply for the annual inspection sticker and update the validity period of the driving license.
14
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.