How to Fix BMW Auto Hold Malfunction?

1 Answers
LaRiver
07/30/25 6:51am
Turn on the car key, press the foot brake, hold the electronic parking brake down for 5 seconds, then pull it up for another 5 seconds. After completing these steps, the electronic parking brake will be initialized and reset. Refers to the manual brake installed in motor vehicles, commonly known as the handbrake. If the electronic parking brake is damaged, the handbrake can be used. The common handbrake is usually located at the right side of the driver for easy access. It can be used after the vehicle is parked to stabilize the vehicle and prevent accidents caused by rolling on sloping roads.
Was this review help?
15
2
Share
More Forum Discussions

Where is the Crown fuel pump relay located?

Crown fuel pump relay is located under the instrument panel at the lower left corner of the driver's side, in the same box as the fuses. A relay is an automatic control device where the output undergoes an abrupt change when the input reaches a certain value. Automotive relays are relays used in vehicles, characterized by their ability to switch high load power and high resistance to impact and vibration. Taking the 2018 Crown as an example, its body dimensions are: length 5020mm, width 1805mm, height 1480mm, wheelbase 2925mm, minimum ground clearance 140mm, fuel tank capacity 70 liters, and the body structure is a four-door, five-seater sedan.
4
5
Share

What is the introduction of automatic transmission gears?

Introduction to automatic transmission gears: 1. The P gear is the parking gear, used for long-term parking of the vehicle. 2. The R gear is the reverse gear, which is engaged when the vehicle needs to reverse. 3. The N gear is the neutral gear, engaged when the vehicle is parked for a short time without turning off the engine. 4. The D gear is the drive gear, when the gear lever is placed in D gear, the vehicle will automatically shift gears based on throttle opening and speed data. 5. The S gear is the sport mode, making the vehicle drive more sporty. 6. The M gear refers to the manual mode, when the gear lever is engaged in M gear, shifting is done manually by the driver. 7. The L gear is the low-speed gear.
2
1
Share

Which group does McLaren belong to?

McLaren belongs to the McLaren Group, which is headquartered in Woking, UK. The models under McLaren include: McLaren 720s, McLaren P1, McLaren 650s, McLaren 675LT, McLaren 12C, etc. Taking the McLaren P1 as an example, it is a hardtop sports car with a body size of: length 4588mm, width 2144mm, height 1188mm, and a wheelbase of 2670mm. The McLaren P1 is equipped with a 3.8T twin-turbocharged engine, with a maximum horsepower of 737PS, a maximum power of 542kW, a maximum torque of 720Nm, and is paired with a 7-speed dual-clutch transmission.
17
2
Share

What lights should be turned on when driving a BMW X3 at night?

When driving at night, the owner can turn on the high beam or low beam as needed, or alternate between the two. Lighting usage instructions: To operate the lights, first ensure the vehicle is in the ignition state. The headlights, width lights, and other lights are controlled by the lighting control knob (or button) on the left side of the driver's seat. The turn signals are controlled by the lighting control lever on the left side of the steering wheel. Turn signal usage: Left turn signal usage: Simply press down the control lever to activate the left turn signal. Right turn signal usage: Lift the control lever upwards to activate the right turn signal. Slightly lifting or pressing the lever without passing the resistance point will cause the side turn signal to flash three times before turning off.
2
1
Share

How to Adjust the Clarity of the Rearview Camera?

To adjust the clarity of the car's rearview camera, follow these steps: 1. Click on Settings. 2. Click on Factory Settings. 3. Click on Rearview and 360-degree Panoramic Settings. 4. Click on the 360-degree Panoramic Switch. 5. Click on the screen to adjust the brightness until the rearview image becomes clear. To set up the rearview camera guidelines: 1. Press the rearview camera button on the center console or shift into reverse gear to activate the rearview camera function. 2. Turn the iDrive knob to the left and select the menu bar on the left side of the icon. 3. The first icon on the left represents turning the rearview camera on or off, and the subsequent icons are for enabling or disabling the rearview guidelines.
3
2
Share

What are the differences between Audi DTA and DKW?

The differences between Audi DTA and DKW are as follows: 1. Different dimensions: The DTA measures 4858mm in length, 1847mm in width, and 1439mm in height; the DKW measures 5038mm in length, 1886mm in width, and 1475mm in height. 2. Different maximum horsepower: The Audi DTA has a maximum horsepower of 150ps, while the DKW has a maximum horsepower of 252ps. Both the Audi DTA and DKW are equipped with a 2.0L turbocharged engine, paired with a 7-speed wet dual-clutch transmission. Both models feature a five-link independent suspension system for the front and rear.
2
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.