How to Fix a Broken Reversing Radar?

2 Answers
ReeseDella
07/24/25 1:51pm
If the reversing radar is not working, first check whether the power cord of the main unit is properly connected, and then check if the radar main unit cable has become loose. If neither of these is the issue, then the reversing radar module or buzzer may be damaged and needs to be replaced. Below are specific details about reversing radars: 1. Obstacles that are too low Generally, obstacles that are 10~15cm below the center of the probe may be overlooked by the radar. Moreover, the closer the obstacle is to the vehicle, the lower this height threshold becomes, increasing the risk. 2. Obstacles that are too thin Since the sound wave signals emitted by the radar probe are relatively narrow, there are significant blind spots when detecting very thin obstacles. Items such as road barriers used to block vehicles and the diagonal steel cables on utility poles can be hazardous. 3. Ditches and bumps The radar is designed to detect obstacles. If there is a ditch or bump behind the vehicle, the radar will not respond at all.
Was this review help?
19
0
Share
McAlivia
08/11/25 7:48am
That day, the reverse radar at the rear of my car suddenly stopped beeping. As someone who often tinkers with my car, I first tried restarting the vehicle and checking for basic faults. If there’s mud or dust covering the sensor surface, the radar signal gets interrupted, so I gently wiped it clean with a soft cloth to see if that worked. Next, I checked the fuse box to locate the corresponding fuse—if it’s blown, it needs replacement, and all this is illustrated in the owner’s manual. If that didn’t help, I inspected the wiring connections for any looseness or damage, using simple tools to test continuity if necessary. If I still couldn’t fix it, I’d either consult a friend for joint diagnosis or head straight to a professional shop to avoid compromising driving safety. Remember, the reverse radar is an assistive tool—routine maintenance should avoid hard impacts and water exposure to prevent frequent issues. Regular cleaning during car washes can extend its lifespan.
Was this review help?
4
1
Share
Expand All
More Forum Discussions

What to Do When the Automatic P Gear Won't Move?

Solutions for when the automatic transmission P gear won't move include: 1. Start the vehicle and shift into another gear; 2. Press the brake pedal to switch gears. Reasons why the automatic transmission P gear won't move are: 1. Not pressing the brake—shifting into P gear requires pressing the brake; 2. The car is turned off; 3. Insufficient transmission fluid; 4. Not pressing the gear lock. The P gear in an automatic transmission is the parking gear, and its working principle is: When the gear lever is in the P position, the parking lock mechanism locks the transmission output shaft, providing braking force even on flat ground without pressing the brake. Other gears in an automatic transmission are: 1. R is the reverse gear; 2. N is the neutral gear; 3. D is the drive gear, also known as the forward gear; 4. L is the low gear.
13
4
Share

Which MINI model is a convertible?

MINI currently offers two soft-top convertible models: the 4-seater MINI CABRIO and the 2-seater MINI ROADSTER. Below is more information about convertibles: Definition: A convertible refers to a car with a foldable and retractable roof. Classification: Convertibles can be categorized into hard-top and soft-top based on roof structure. Soft-tops are more common, typically using canvas, vinyl, or plastic as roof materials with foldable supports. Hard-tops feature metal roofs that usually can be automatically opened and closed. Additional Information: Some convertibles are specifically developed as dedicated convertible models without other variants, such as the Mazda Miata or Volkswagen Cabriolet. Most convertibles, however, have both convertible and fixed-roof versions. Some convertibles are derived from popular sedan models, like the Volkswagen Beetle convertible. Most convertibles are two-door models, with four-door versions being relatively rare.
7
1
Share

What Causes the Smell of Gasoline When Starting a Car?

Reasons for the smell of gasoline when starting a car are as follows: 1. Insufficient air intake by the car's throttle, leading to incorrect air flow information. 2. Excessive carbon buildup in the cylinder combustion chamber and pistons, resulting in insufficient cylinder pressure. 3. Excessive carbon deposits inside the engine, causing poor atomization of the air-fuel mixture. 4. Leakage in the gasoline pipe, forming sludge at the pipe connections, with the odor entering the car through the air conditioning system. Solutions for the smell of gasoline when starting a car include: 1. Replace the rubber hoses of the gasoline purification carbon canister. 2. Tighten or repair the gasoline pipe connections. 3. Repair or reassemble the fuel pump.
15
0
Share

What is the timing alignment method for Jinbei CG14?

Before adjusting the ignition timing, the contact gap must be adjusted to a range of 0.35 to 0.40 millimeters. Slowly rotate the crankshaft. When a hissing sound is heard, it indicates that the first cylinder is in the compression stroke. Open the inspection hole cover on the flywheel housing and then slowly rotate the crankshaft again. Loosen the fixing screw of the distributor housing. Rotate the housing along the direction of the distributor shaft until it is in the closed position. Turn on the ignition switch until sparks stop. Reinstall the distributor rotor. Insert the high-voltage wire of the first cylinder into the wire hole on the distributor cap aligned with the conductive piece of the distributor rotor. Insert the high-voltage wires of the other cylinders in a clockwise direction. Start the engine and let it run until it reaches normal operating temperature. Suddenly accelerate. If the engine emits a brief and slight knocking sound and it immediately disappears, the ignition timing is appropriate.
17
0
Share

When Can a Beginner Drive Alone?

Beginners can drive alone immediately after obtaining their driver's license, but they are not allowed to drive on highways alone during the probationary period. They must have a driver with a corresponding or higher-level license in the passenger seat to guide them. Below are specific details about the driver's license: Probationary Period: The probationary period for a C1 driver's license is one year. After this period, there is no need to review or renew the license at the vehicle management office; the license can continue to be used. License Validity Period: The initial driver's license is valid for six years. Ninety days before the six-year validity period expires, the license must be renewed at the vehicle management office. License Points: A driver's license has a total of 12 points. If caught violating traffic rules, points will be deducted based on the severity of the violation. The points reset every 12 months from the date the license was issued. License Revocation: If a driver accumulates 12 points within a single point cycle, their license will be revoked, and they must reapply and retake the subject four exam.
12
0
Share

Can a car with modified body kit pass the annual inspection?

Modifying the body kit of a car will prevent it from passing the annual inspection. Here are the relevant details: 1. The new "Road Traffic Safety Law" clearly stipulates that no unit or individual may assemble a motor vehicle or alter the structure, construction, or characteristics of a motor vehicle without authorization. The structure of a vehicle includes the body color, length, width, height (four rigid standards), and the relevant technical parameters of the engine. 2. Before modifying a licensed car, the owner must register and declare the modification to the vehicle management office. The modification can only proceed after the technical report is reviewed and approved by the vehicle management office. After the modification is completed, the owner must also complete the modification change procedures at the vehicle management office. 3. Whether a vehicle modification is legal depends on whether the vehicle matches the photo on the driving license and whether it complies with the factory technical parameters. If it does not match, the vehicle will not pass the annual inspection.
20
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.