How to Find the 30cm Point for Pulling Over?

1 Answers
SamuelLee
07/30/25 6:28am
Align the driver with the center of the road, then slightly adjust to the right. Position the front one-third of the car's hood on the right lane edge line and straighten the vehicle. Slowly brake when the car is approximately 30cm away from the edge line to bring the vehicle to a stop. Relevant details are as follows: 1. Wiper Method: Observe the wiper. When the gap in the wiper aligns with the edge line while moving forward, the car is approximately 30cm from the edge line. Alternatively, look at the car's hood reinforcement line—the raised line on the right side of the hood. When this line aligns with the edge line while moving forward, the distance is also roughly 30cm. 2. Parking Restrictions: Remember that when pulling over, parking is prohibited in the following areas: intersections, railway crossings, curves, narrow roads, narrow bridges, steep slopes, tunnels, and within 20 meters of these locations; sections with pedestrian guardrails (hedges), crosswalks, construction zones, or opposite obstacles; bus stops, tram stops, emergency stations, gas stations, fire hydrants, or within 30 meters in front of fire stations.
Was this review help?
8
4
Share
More Forum Discussions

Can Coolants of Different Colors Be Mixed?

Coolants of different colors should not be mixed, as doing so can cause chemical reactions that render the coolant ineffective. Reasons for different coolant colors include: 1. To distinguish between different coolant formulations—since both water and antifreeze agents are colorless, varying formulations cannot be visually differentiated without added dyes; 2. To clearly identify leaks and help locate the source; 3. To easily monitor coolant levels in the radiator, ensuring timely replenishment. Coolant, short for antifreeze coolant, is designed to prevent freezing in cold weather, protecting the radiator from cracking and the engine block or cylinder head from damage due to frozen coolant.
9
0
Share

Should I Shift to N Gear When Using Auto Hold?

Whether to shift to N gear when using auto hold depends on the duration of parking. If the parking time is short, there is no need to shift to N gear, and you can keep the car in drive gear. If the parking time is long, then you should shift to N gear. Auto hold refers to an automatic braking function that, when activated, eliminates the need to use the handbrake or electronic parking brake while waiting at traffic lights, simplifying the operation. The auto hold system is a technological application that enables an automatic handbrake function while the car is running. This technology allows drivers to avoid prolonged braking when the vehicle is stationary and prevents unnecessary rolling of the vehicle when the automatic electronic parking brake is engaged.
15
4
Share

How often should a car be inspected after six years?

After six years, a car should be inspected annually, and those over 15 years old should be inspected every six months. New cars within the first six years are exempt from on-site inspections, but it is important to apply for an inspection mark from the traffic management authorities every two years; otherwise, it will be considered as missing the inspection. Note that SUVs and MPVs with seven seats or more do not qualify for the six-year exemption policy. Vehicle annual inspection refers to a mandatory test for every vehicle that has obtained an official license plate and registration certificate, equivalent to an annual physical examination for the vehicle according to the safety technical conditions for motor vehicle operation. Vehicle annual inspections help promptly eliminate potential safety hazards, encourage better maintenance of the car, and reduce the occurrence of traffic accidents.
18
2
Share

How to Cool Down an Overheated Car Engine?

Methods to cool down an overheated car engine: 1. Find a safe place to pull over, but do not turn off the engine immediately. Allow the engine to idle to continue dissipating heat, and open the hood to enhance cooling. 2. After some time, check if there is any leakage under the car. 3. Wait until the temperature gauge needle drops to a safe level before turning off the engine. 4. Use a wet towel to cover the radiator cap, then open the first switch (about a quarter turn). After the steam pressure is fully released, completely open the radiator cap to check the water level and quality in the radiator, and inspect the fan belt for any abnormalities. 5. If the water level is insufficient, slowly add water up to near the maximum fill line.
5
5
Share

How to Remove the Spare Tire of BMW X6?

Methods to remove the spare tire of BMW X6: 1. Hidden spare tire: Lift the trunk floorboard, open the device that secures the spare tire, and take out the spare tire; 2. Rear-mounted spare tire: Open the anti-theft lock to remove the protective cover of the spare tire, use a wrench to unscrew the nuts securing the spare tire, and then remove the spare tire; 3. Underbody-mounted spare tire: Remove the dust cover to reveal the screws, connect the screw socket to the screw port, and lower the spare tire by rotating the traction rope, causing the spare tire to descend. The BMW X6 is defined as a versatile coupe, with body dimensions of 4880mm in length, 1983mm in width, 1709mm in height, and a wheelbase of 2933mm.
1
2
Share

What to Do When Your Car's One-Button Start Key Runs Out of Battery?

Solutions for a one-button start key running out of battery: 1. Vehicles with one-button start usually have a smart key slot. When the key runs out of battery, insert the smart key into this slot, and the vehicle will detect the key's presence to start the engine; 2. Some one-button start models have a metal key ignition slot. Locate this slot and insert the key blade from the remote key, then start the vehicle as you would with a regular car; 3. Place the remote key against the one-button start button or other sensing area. Wait a moment for the vehicle to detect the key, then you can start the engine.
15
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.