How to Engage First Gear and Reverse Gear in a Manual Transmission?

How to Check the Wear Level of Teana Brake Pads?

To check the wear level of Teana brake pads: 1. Observe the raised indicators at both ends of the brake pads, which are 2 to 3 mm thick—this is the minimum replacement limit for the brake pads; 2. Listen for a sharp, screeching sound, which indicates that the thickness of the brake pads has fallen below the limit markers on both sides. Taking the 2021 Teana as an example, its body dimensions are: length 4901mm, width 1850mm, height 1450mm, with a wheelbase of 2825mm. The 2021 Teana is equipped with a 2.0L naturally aspirated engine, delivering a maximum power of 115kW and a maximum torque of 197Nm, paired with a CVT continuously variable transmission.

3

4

Share

What brand are the original tires on the Hyundai Tucson?

The original tires on the Hyundai Tucson are from brands such as Bridgestone, Kumho, or Nexen, with the original tire specification being 225/55R18. Taking the 2020 Hyundai Tucson as an example, it belongs to the compact SUV category, with body dimensions of: length 4545mm, width 1850mm, height 1670mm, and a wheelbase of 2670mm, with a curb weight of 1545kg. The 2020 Hyundai Tucson features a MacPherson strut front suspension and a multi-link independent rear suspension. It is equipped with a 1.6L turbocharged engine, delivering a maximum horsepower of 177PS, a maximum power of 130kW, and a maximum torque of 265Nm, paired with a 7-speed dual-clutch transmission.

17

2

Share

What Are the Reasons for No Response When Turning the Car Key?

The reasons for no response when turning the car key are: 1. The car battery is low on power; 2. There is an issue with the car's ignition system; 3. The car steering wheel is locked; 4. A fuse is blown, the high-voltage coil is open-circuit, or the low-voltage circuit is open-circuit; 5. The central ignition wire is detached, the distributor rotor is leaking electricity, or the spark plug is damaged. The functions of the car key are: 1. Closing the windows after turning off the engine, as the windows will automatically rise and close; 2. Making it easier to locate the car in a parking lot; 3. Automatically opening the trunk; 4. Remotely opening the windows. Precautions for using the car key are: 1. Do not place it together with electronic devices; 2. Avoid exposing the key to high temperatures or direct sunlight; 3. Do not use batteries of different power levels.

18

1

Share

What is the suitable tire pressure for Changan Oshan X7?

The normal tire pressure range for Changan Oshan X7 is 2.4-2.5bar. Due to seasonal factors, the tire pressure can be appropriately increased by 0.2bar in winter and decreased by 0.1bar in summer. This data complies with the international GBT2978-2008 standard. The tire pressure monitoring for Changan Oshan X7 can be viewed on the dashboard. The vehicle is equipped with an automatic tire pressure monitoring system that alerts without manual operation. This tire pressure monitoring system uses ABS wheel speed sensors to compare the rotational speed differences between tires to determine if there is abnormal tire pressure. If an abnormality is detected, it immediately alerts. The module is integrated into the ABS pump. Generally, a tire pressure exceeding 2.8bar is considered too high, and a tire pressure below 2.0bar is considered too low. Hazards of overinflated tires: Reduced tire friction and adhesion, affecting braking performance; causes steering wheel vibration and deviation, reducing driving comfort; accelerates wear on the central tread of the tire, shortening tire lifespan; increases vehicle vibration, indirectly affecting the lifespan of other components; overextends the tire cords, reducing tire elasticity and increasing the load on the vehicle during driving. Hazards of underinflated tires: Increased friction coefficient with the road surface, leading to higher fuel consumption; causes heavy steering and deviation, posing safety risks; increases movement in various parts of the tire, leading to excessive rolling and abnormal heat generation; reduces the functionality of cords and rubber, causing delamination or cord breakage and excessive friction with the rim, damaging the bead area and causing abnormal wear; multiplies friction between the tire and the ground, sharply raising tire temperature, softening the tire, and drastically reducing strength. High-speed driving may lead to tire blowouts. If the tire pressure monitoring indicator light comes on (a yellow symbol with an irregular circle, no stamp on top, four small spikes at the bottom, and an exclamation mark inside), there are generally three possible reasons: Abnormal tire pressure. Usually, it alerts when the pressure is below 1.8bar or above 3.0bar. In this case, tire inspection and pressure adjustment are needed. Tire pressure monitoring not reset. After inflating the tires, if the tire pressure is not reset in time, the system still records the previous data, causing the indicator light to come on. Simply reset the tire pressure to resolve this. Damaged tire pressure sensor. The tire pressure sensor, which monitors tire pressure, is directly installed inside the tire and connected to the tire inflation valve. If the sensor is damaged during driving, it can also trigger the tire pressure warning light. For sensor damage, the only solution is to replace it with a new one.

4

5

Share

Does Insurance Cover Spontaneous Combustion?

Vehicle spontaneous combustion loss insurance is an additional coverage to vehicle damage insurance, and only vehicles insured with vehicle damage insurance are eligible for this coverage. Below is relevant information regarding vehicle insurance compensation: Compensation Amount: For insured motor vehicles, if a fire occurs during use due to faults in the vehicle's electrical system, wiring, fuel supply system, or due to the nature of the transported cargo, resulting in damage to the insured vehicle, as well as necessary and reasonable rescue expenses incurred by the insured to minimize vehicle loss during an incident covered by this insurance, the insurance company will compensate based on the actual loss of the vehicle within the insured amount specified in the policy. In case of total loss, compensation will be provided based on the actual value of the vehicle at the time of the incident within the insured amount specified in the policy. The absolute deductible rate for this insurance is 20%. Exclusions from Compensation: The insurance company will not compensate for losses caused by the insured's violation of vehicle safety operation rules, such as manual direct fuel supply or open flame heating, or losses limited to the electrical system, wiring, fuel supply system, and cargo itself due to spontaneous combustion, as well as losses resulting from intentional acts of the insured.

11

3

Share

Where is the best position to install ETC in a car?

The ETC installation position is generally on the upper middle part of the front windshield for regular vehicles, while for large vehicles like trucks and buses, it is installed on the lower middle part. The appropriate installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with explosion-proof film or those that have it installed later, it may affect the signal transmission of the microwave communication link, so it should be installed in the microwave sunroof strip. ETC is the abbreviation for Electronic-Toll-Collection, meaning electronic toll collection system. To apply, you need to provide the original and photocopies of the vehicle owner's valid ID card and vehicle license. If the application is not made by the owner, the agent's valid ID card is also required. The photocopy of the vehicle license should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also needed, and the vehicle must be registered under an individual's name aged between 18 and 60. Documents required for company vehicles: Introduction letter from the vehicle owner (with official seal); Photocopy of the organization code certificate or business license (with official seal); Original ID card of the agent; Original vehicle license; The vehicle that needs to apply for ETC. Here are some precautions for installing ETC: Do not block the view, it is best to install it behind the rearview mirror: Many car models have a large inclination angle of the windshield, which reduces the driver's field of vision. If this is not considered when installing ETC, it will increase the driver's blind spot. Install it behind the right side of the rearview mirror to avoid blocking the view. Do not affect charging: The ETC electronic tag consumes power, but generally does not need to be charged or have its battery replaced because it has a solar panel on the back for self-charging. Therefore, when installing, avoid the black areas on the windshield and do not install it in a position that easily blocks the solar panel. Do not remove it casually once installed: The button in the middle of the adhesive is an anti-removal lever, connected to a switch below. After the electronic tag is installed, the windshield will press the anti-removal lever in. If it is removed casually, the anti-removal lever will pop out and trigger the switch, locking the electronic tag and making it unusable. You will then need to go to an ETC service point to unlock it. This is designed to prevent multiple vehicles from sharing one device.

1

0

Share

How to Engage First Gear and Reverse Gear in a Manual Transmission?

How to Check the Wear Level of Teana Brake Pads?

What brand are the original tires on the Hyundai Tucson?

What Are the Reasons for No Response When Turning the Car Key?

What is the suitable tire pressure for Changan Oshan X7?

Does Insurance Cover Spontaneous Combustion?

Where is the best position to install ETC in a car?

Shift Gear First or Release Handbrake First?

Where is Changan Mazda cars produced?

Does Leaving the Car in P Gear Without Turning Off the Engine Have Any Impact?

Does the Captiva have a ladder frame chassis?