How to Eliminate the Maintenance Reminder Sound?

1 Answers
TheoLee
07/29/25 3:36pm
Here are the methods to eliminate the maintenance reminder sound: 1. Turn on the car's ignition switch, then use one hand to press and hold the [Reset Button 5], while using the other hand to turn off the ignition switch. 3. At this point, start over again by continuing to press and hold the [Reset Button 5] with your hand, then turn on the car's ignition switch once more. When you see the maintenance reminder flashing on the dashboard, you must keep pressing the [Reset Button 5] until the car's maintenance reminder stops flashing, then release the button. 4. After releasing the button, turn on the car's ignition switch again to check if the reminder has been cleared. 5. Press and hold the MODE button, then turn off the car's ignition switch.
Was this review help?
2
3
Share
More Forum Discussions

How to Determine if ETC is Working Properly?

Remove the ETC bank card. Reinsert the ETC bank card into the electronic tag. When the electronic tag screen displays 'Debit Card' or an amount, the ETC is functioning normally.
19
5
Share

How to Resolve a Lean Fuel System?

Use professional diagnostic equipment to read the fault codes stored in the ECU. Read the data stream to check for any abnormalities. Inspect for any blockages, remove the oxygen sensor, and check if sensor poisoning is caused by poor fuel quality.
17
3
Share

What to Do When the Car's One-Button Start Fails to Ignite?

Turn the steering wheel forcefully while twisting the key to release the steering wheel lock, then attempt to start the engine. Place the smart key on the start button and then press the button to start.
18
2
Share

What is the transfer process for a private second-hand motorcycle?

The seller should bring the vehicle license, registration certificate, and both parties' ID cards to the local second-hand vehicle trading market to pay the second-hand vehicle transaction tax. The buyer and seller should bring all the documents to the traffic management office where the motorcycle is registered to complete the motor vehicle transfer.
6
5
Share

How to Repair a Broken Car Bumper?

Observe how to remove the bumper, and you can look up the removal method. Align the cracks on the bumper and use transparent tape to secure the cracks in place to prevent deformation or misalignment during operation. Plug in the prepared soldering iron, then flip the bumper over to inspect the cracks on the inside.
6
0
Share

What is the repair process for a flooded vehicle?

If the water level does not exceed one-third of the tire height, there is no need to worry too much. Simply perform a basic inspection to eliminate potential hazards. If the water exceeds one-third of the tire height, promptly clean the sound insulation cotton.
8
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.